Download presentation
Presentation is loading. Please wait.
Published byJuliana Gordon Modified over 9 years ago
1
ED 103: splinting basics Thao M Nguyen, MD Daniel A Hirsh, MD Pediatric Emergency Medicine Emory University Children’s Healthcare of Atlanta
2
2 Objectives Indications & Contraindications Basic Principles Common Mistakes Prepare patient/parent Step-by-step instructions Complications Discharge Instructions
3
3 Indications Temporary immobilization Protection Pain control
4
4 Contraindications Compartment syndrome Need for open reduction Skin at high risk for infection
5
5 Basic Principles Temporary Non-circumferential Non-weight bearing Protect the skin Pad bony prominences Place a dry splint
6
6 Common Mistakes Placement of a Circumferential splint Placement a Wet splint Placement of a Tight Splint Not allowing time for the fiberglass to adequately harden
7
7 Patient/Parent Expectations Placement should not hurt Most injuries feel significantly better with splinting alone Splint material will get warm when it hardens Should be snug, not tight Fingers & toes shouldn’t tingle or turn deep purple
8
8 Step 1: Choose your splints
9
9 Choosing the splint types: upper extremities Volar Distal radius/ ulna & wrist fx Sugar Tong Distal radius/ ulna & wrist fx Long Arm Elbow & forearm injuries - Fleisher, 2006 -
10
10 Choosing the splint types: upper extremities Ulnar Gutter Boxer’s fx and uncomplicated 4 th & 5 th phalangeal fx Radial Gutter 2 nd & 3 rd MCP or phalangeal fx - Fleisher, 2006 -
11
11 Choosing the splint types: upper extremities Thumb Spica Nonrotated, nonangulated, nonarticular fx of the thumb MCP or phalanx; gamekeeper’s thumb; scaphoid (navicular fx) Buddy Tape - Fleisher, 2006 -
12
12 Choosing the splint type: lower extremities Posterior leg Foot, ankle & distal fibula fx Ankle sprains Stirrup Foot, ankle & distal tibia/fibula fx Cadillac Splint - Fleisher, 2006 -
13
13 Step 2: Gather all of your supplies
14
14
15
15 Splinting Material
16
16 Stockinette
17
17 “Cotton Wadding” “Cast Padding”
18
18 Ace wrap
19
19 Shears
20
20 Step 3: Protect the skin
21
21 Apply stockinette to extremity Extend it past the proximal and distal ends of where the splint will end
22
22 Cut out any areas that bunch up that could damage the skin
23
23 Create thumb hole
24
24 Protect bony prominences
25
25 Cut splint material to proper size
26
26 Protect the skin by creating ~1.5 cm border of cotton by cutting the fiberglass
27
27 Step 4: Activate the Fiberglass
28
28 Approximate initial hardening times Ambient Humidity: 15 min Cold Water: 5 min Hot Water: 2 min
29
29 Hot water will cause the fiberglass to harden very quickly
30
30 Cold water
31
31 Keep padding as dry as possible
32
32 Protect the skin. If cotton padding is wet, dry it.
33
33 Some fiberglass material comes with a thick padded side and a thin side. Protect the skin. Always place the thick-side to the skin-side.
34
34 Step 5: Apply the Splint
35
35 Wrap the splint in place—not too loose or too tight. Protect the skin. Do not apply pressure with finger tips, use a curved palm.
36
36
37
37 Allow time for the fiberglass to cure
38
38 Step 6: Check splint placement Make sure patient has normal sensation distal to splint Make sure there is normal capillary refill after splint placement Make sure the splint does not cause any pain
39
39 Splint Complications
40
40 Discharge Instructions Protect the skin. Keep splint dry If extremities become tingly or blue, re-wrap the bandage Don’t allow weight bearing on the splint If splint hurts, or there is increasing pain, TAKE THE SPLINT OFF! Seek medical attention
41
41 Case 1 12 yo female s/p bike accident, fell and landed on wrists
42
42 Case 2 3 yo male fell while running and landed on leg
43
43 Case 2
44
44 Case 3 16 yo female with left wrist injury ~ 6 wks ago. Extremity was splinted w/o reduction; unable to F/U with orthopedics
45
45 Suggested Reading Fleisher, GR. Textbook of Pediatric Emergency Medicine, 5 th ed, 2006
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.