1. Acoustic Target Tracking Using Tiny Wireless Sensor Devices Qixin Wang, Wei-Peng Chen, Rong Zheng, Kihwal Lee, and Lui Sha Dept. of CS, UIUC

2. Introduction Context –Delay based sound source locating algorithm, requires large number of redundant sensors for accuracy. -Tiny wireless sensors to real-world acoustic tracking applications. –Tracking only impulsive acoustic signals, such as foot steps, sniper shots etc. No concept of tracking motion.

3. Challenges: –Partial info at one sensor site –Inaccuracy and unreliability of sensors –Effective use of scarce wireless bandwidth Solutions: –Sensor clustering and coordination –Redundancy for robustness –Quality-driven (QDR) networking. Info. flow oriented v.s. raw data flow oriented. Introduction

4. Sink/ Pursuer Cluster Head Scenario Sensor Router Cluster Head Sink/Pursuer

5. System Overview System Architecture –Acoustic target tracking subsystem Sensor (mica motes) Cluster Head (mono-board computer) Sensors belong to clusters with singular cluster head. Cluster head knows the locations of its slave sensors. Raw data gathered from sensors are processed in cluster head to generate localization results

6. –Communication Subsystem: route back the reports generated by cluster heads to sink Sink cluster covered area router (mica motes) cluster head System Overview

7. Use RBS Time Synch (error  30  s). Onset Detection (on sensors) –Small sliding window to compute moving average of acoustic signal magnitude. –Use threshold to detect onset time t 0. –Record one buffer load of data, then post- process. Acoustic Target Tracking Subsystem

8. Cross Correlation (to find out delays) Detected intersted sound Cluster Head: Broadcast sound signature Cross- correlation to detect local arrival time Slave Sensor: Report local arrival time Locate sound src loc. Acoustic Target Tracking Subsystem

9. Sound Source Locating & Evaluation of Quality Rank (main idea) –Throw away apparently erroneous sensor readings. –Let A = cluster’s monitored area, sound src location = arg  p  A min{|d(p) - d s |}, where d(p) is the hypothetical sensors’ sound arrival time vector, while d s is the actual one. |·| is an error measurement function. Acoustic Target Tracking Subsystem

10. –In practice, we cannot check every location in A, instead, we apply a grid with 3  3inch 2 granularity onto A, and only check those grid points. –Quality Rank = percentage of d(p)’s elements that falls outside  boundary of d s. Acoustic Target Tracking Subsystem

11. Communication Subsystem Quality-driven(QDR) Redundancy Suppression and Contention Resolution –Redundant clusters may report same event’s location. Good for reliability reasons. –Quality Rank is used to suppress inferior reports and only report high quality rank localization reports to data sink

12. –Quality Rank is also used for contention resolution along the routes (with CSMA as MAC) to let higher quality reports get to data sink earlier: T backoff = QualityRank  interval + random Acoustic Target Tracking Subsystem

13. Experiment Locations of sensors and sound sources in a single cluster

14. Examples of localization results for different sound source locations Experiment

15. Average error vs. sound source locations. Note sound source is a 4inch speaker Experiment

17. % of reports within 3- inch error range: higher quality rank, higher creditabi- lity Experiment

18. Quality- driven (QDR): Effect of various interval on the percen- tage of suppressed reports Experiment

19. Effect of Quality-driven(QDR) Suppose info/bit is fixed; the smaller Quality Rank, the better the quality. Experiment

20. Conclusion Acoustic target tracking using tiny wireless devices with satisfying accuracy is possible. Quality Rank can be used to decide the quality of tracking result Quality-driven redundancy suppression and contention resolution is effective in improving the information throughput.