Presentation is loading. Please wait.

Presentation is loading. Please wait.

Circuit Lab. Experiment-3 Operating the function generator and digital oscilloscope.

Similar presentations


Presentation on theme: "Circuit Lab. Experiment-3 Operating the function generator and digital oscilloscope."— Presentation transcript:

1 Circuit Lab. Experiment-3 Operating the function generator and digital oscilloscope

2 Quiz A(t)=5.sin(100  t) –Draw the graphic of A(t) signal –Calculate amplitude, frequency and time period.

3 FUNCTION GENERATOR GW INSTEK SFG-2120 -Generation of Test Signals -Square Wave -Sine Wave -Triangular Wave -Digitally Controlled Frequency (0.1 Hz... 20 MHz) -Manually Controlled Amplitude (0...10V (pp)) -50 ohm BNC output -TTL/CMOS BNC output -Counter BNC input for frequency counter -Amplitude, Frequency Modulation, Variable Mod. index

4 FUNCTION GENERATOR GW INSTEK SFG-2120

5

6

7

8

9

10 How can we see the signal? Oscilloscope  GW Instek GDS 1102  100 MHz  2 channels  1 M ohm input impedance  FFT, A*B, A+B, A-B  Digital Measurements (Vpp, Vdc, Frequency...)  Saving Graphical Data (SD Card Interface)

11 DIGITAL OSCILLOSCOPE GW Instek GDS-1102

12 Connection BNC Connectors (RF Connector) (British Naval Connector)

13 Cable RG-58/U Coaxial Cable Low-power signal and RF connections Characteristic impedance: 50 ohm A: outer plastic sheath B: woven copper shield C: inner dielectric insulator D: copper core

14 Oscilloscope Probe

15 Equivalent Circuits 1x Probe R1=1M ohm C1=1-10 pF 10x Probe R1=9M ohm C1=1-10pF Oscilloscope Input R2=1M ohm C2=20 pF

16 Osilloscope Probe Test Check the probe set : 1x or 10x Connect the BNC connector of the Oscilloscope Probe to CH1 Connect the test connector of the oscilloscope probe to Test Output Press Run/Stop Key Measure the frequency and the amplitude of the test signal

17 Osilloscope Probe Compensation

18 Volt Division of CH1 Volt Division of CH2 Time Division

19 1 st Job: A(t)=5.sin(100  t) –Amplitude? peak (p) peak-to-peak (pp) –Time period? (seconds) –Frequency? (Hertz)

20 2 nd Job Derive the sine signal using function generator and oscilloscope

21 3 rd Job Generate –4 V (p-p) –10 kHz –Square Wave

22 4 th Job Generate –100 mV (p-p) –1 kHz –Sine Wave

23 Cursors


Download ppt "Circuit Lab. Experiment-3 Operating the function generator and digital oscilloscope."

Similar presentations


Ads by Google