1. Configuring Linksys Wireless Ethernet Bridge Prof. Yousif @ Valencia Community College

2. Wireless Ethernet Bridge Home Page Default Address 192.168.1.225

3. Enable LAC#5

4. The default SSID is “linksys” unless a beacon is heard with a different SSID

5. Basic Configuration admin Change to WB#, where “#” refers to your PC number Default PW is: admin

6. Basic Configuration Auto sensed from the beacons broadcasted by the Cisco AP

7. Basic Configuration Must enter GW Address

8. No Security Config. “Later”

9. Confirm!

10. Web Access: Open your browser and type the address you used during configuration: 10.0.0.3 Make sure that you Ethernet Card is configured to be on the same network

11. Confirm Association IP Add. Of PCMAC Add. Of W. Bridge

12. Check the Firmware Version Old

13. Upgrade the WB Firmware

14. Download the firmware Capture

15. Install firmware Upgrade Make Sure that you enter the correct IP address of the WB and the correct password

16. Site Survey

17. Supports WEP Only, Doesn’t Support WPA