1. S YRINGES & N EEDLES Instructor – Cindy Quisenberry

2. T YPES OF SYRINGES TB Syringe (1 ml) Insulin Syringe (measures in units) 3 ml Syringe 5 ml Syringe 10 ml Syringe 20ml Syringe 50 ml Syringe 60 ml Syringe Luer Lock Syringe Slip Tip Syringe Catheter Tip Syringe

3. S YRINGES

4. L UER -L OCK

5. S LIP T IP

6. P ARTS OF A SYRINGE Barrel (non-sterile) Flange on the Barrel (non-sterile) Plunger (rubber portion and the shaft are sterile) Flange on the Plunger (non-sterile) Syringe Tip (Needle Attachment – sterile) Calibrated Scales – markings vary from 0.01 on 1 ml syringe to 0.2 ml on 3-5 ml syringe; insulin syringes measure in units (1 or 2 units) always check the calibrated scale

7. M AJOR TYPES OF NEEDLES Gauges (diameter) 14-28 gauge Length (how long the needle is) ¼ inch – 3 inch

8. N EEDLES

9. P ARTS OF A N EEDLE Lumen – hollow cavity inside the needle Bevel – cutting edge of the needle Hub – point of attachment to the syringe Cannula (Shaft) – needle length Cap – Protective cover

10. P ARTS OF A SYRINGE Barrel Plunger Flange Rubber tip Hub Shaft/ Cannula LumenShaft Bevel Tip

11. K EEP IT STERILE 1. The Needle must never touch anything which isn't sterile. 2. The barrel tip of the syringe should also not touch anything except the needle's hub end. (this could contaminate the entire interior of the barrel) 3. The rubber plunger should not be touched. 4. The area of the plunger that extends into the barrel should also be avoided. So, that leaves just the outer barrel, the finger flange, and the thumb tip of the plunger.