1. Chapter 4 Force Ewen et al (2005) Objectives: Identify components of friction. Analyze forces in one dimension.

2.  Friction is a force that resists the relative motion of two objects in contact with each other.  Caused by irregularities in the two surfaces sliding or rolling across each other. Figure 5.5 Friction resists motion of objects in contact with each other.

3.  Friction is both a necessity (good) and a hindrance (bad).  Experiments indicate the following general characteristics for frictional forces. 1. Friction is a force that always acts parallel to the surface in contact and opposite to the direction of motion. 2. Starting friction is greater than sliding friction. 3. Friction increases as the force between the surfaces increases.

4. Figure 5.6 Friction increases as the force between the surfaces increases.

5.  Friction can be described with the following equation: where F f = frictional force F N = normal force (force perpendicular to the contact surface.)  = coefficient of friction  The coefficient of friction (  ) is the ratio between the frictional force (F f )and the normal force (F N ).

6. MaterialStarting FrictionSliding Friction Steel on steel0.580.20 Steel on steel (lubricated)0.13 Glass on glass0.950.40 Hardwood on hardwood0.400.25 Steel on concrete0.30 Al on Al1.9 Rubber on dry concrete2.01.0 Rubber on wet concrete1.50.97 Al on wet snow0.40.02 Steel on Teflon0.04

7.  Use smoother surfaces (but not too smooth).  Use lubrication to provide a thin film between surfaces.  Use Teflon to greatly reduce friction between surfaces when an oil lubricant is no desirable, such as electric motors.  Substitute rolling friction for sliding friction. Use wheels or bearings.

8.  A force of 170 N is needed to keep a 530-N wooden box sliding on a wooden floor. What is the coefficient of sliding friction?