1. Programming instructions.

2. To set the time Pool pump and heat pump must be ON. Pictrue 1Picture 2Picture 3 1.Press, the hour will flash (picture 1) 2.To adjust the first two numbers press a second time on and press on the arrow up or down to set the time. (picture 2) 3.To adjust the minutes push a 3 rd time on to make the minutes flash, and push the arrow up or down to set the minutes. (picture 3) 4.Push one last time on to confirm the time. Please note you will have 3 to 4 seconds between each step to complete the adjustments.

3. Start the heat pump. The pool pump must be ON. Picture 1Picture 2Picture 3 1.When the breakers is ON you will see this ( Picture 1) 2.To start the heat pump, start your pool pump first and next your heat pump, see ( Picture 2) 3.You will then see the water temperature appear. To increase water temperature Example: 68 then push on the up arrow (Picture 3)

4. To set the Timer Pool pump and heat pump ON. Picture 1Picture 2Picture 3 1.To set the timer according to operating mode press the TIMER ON figure 1) 2.To set the start time of the heat pump press a second time TIMER ON, the first two digits will flash, adjust by pressing or arrows, press a third time on TIMER ON to adjust the minutes. (Picture 2) 3.Press one last time on TIMER ON to confirm your choice. (Picture 3) 4.Repeat steps 1 through 3 for the TIMER OFF. Please note you will have 3 to 4 seconds between each steps to complete the adjustments.

5. Removing the timer. Pool pump and heat pump ON. Picture 1Picture 2Picture 3 1.To remove the timer (ON & OFF) press TIMER ON, the numbers will flash then press on CLOCK. ( Picture 1 & 2 ) 2.Repeat procedure for the timer OFF (Picture 3) Please note you will have 3 to 4 seconds between each step to complete the adjustments.

6. To return to factory settings. Pool pump ON and heat pump OFF. Picture 1 Picture 2Picture 3 1.Put the heat pump on stand-by press on 2.Press at the same time MODE & CLOCK for about 3 seconds (Picture 1 ) 3.Press the left arrow to see the parameters 0 to 9 and the parameters a,b,c,d,e, and compare them with those in your owner’s manual. (Picture 2) 4. If there are differences, select the setting to be changed from 0 to 9 press on MODE and at the same time and press on an arrow to change the numbers. ( Picture 3 )