1. After Receiving this error code, Follow these steps to correct the problem… Click for next slide

2. You will need a 6inch Philips head screwdriver Click for next slide

3. 8mm box wrench Click for next slide

4. Remove screw from panel close to the control panel Click for next slide

5. Then slide the panel to the right… Click for next slide

7. This L.E.D. light should be on, but with this type of error, it will be off… Click for next slide

8. This part is called the “Spanner”, and is what you will adjust to correct the error. Click for next slide

9. A closer look… Click for next slide

10. With the 8mm box wrench, adjust the spanner with a slight turn left or right… Click for next slide

11. Until the L.E.D. light is on Click for next slide

12. Press the “clear” button and clear the error from the screen. Click for next slide

13. Press the “thread cut” button, and your done!