Download presentation
Presentation is loading. Please wait.
Published byPreston Walker Modified over 9 years ago
1
Interaction of Gamma-Rays - General Considerations uncharged transfer of energy creation of fast electrons
2
photoelectric Compton pair production photodisintegration Interaction of Gamma-Rays - Types
3
Photoelectric Effect Einstein, 1905, as part of his Nobel prize winning paper on the photon theory of light - a prediction which was later verified experimentally in detail photon absorbed by atom, goes into excited state and ejects an electron with excess kinetic energy:
6
Photoelectric Effect
7
but can also be expressed as a work function, a constant term "eW o " which varies from material to material eV S = h - eW o where: h (the slope) remains constant for all material being equal to Planck's constant; 6.6 10 -34 J-s
8
there exists a threshold frequency: hV th = eW o below this threshold photons will not have sufficient energy to release even the least tightly bound electrons cross-section drops abruptly at the K-edge because below there is insufficient energy to overcome the binding and the K-shell electrons no longer participate the L-edge is really 3 energies due to fine level splitting Photoelectric Effect
9
K-shell binding energies vary from 13.6 eV (H); 7.11 keV (Fe); 88 keV (Pb); 116 keV (U); if hν < E k, only L and higher shell electrons can take part photoelectric effect favored by low-energy photons and high Z absorbers; cross-section varies as: strong Z-dependence makes Pb a good x-ray absorber, usually followed by Cu and Al in a layered shield Photoelectric Effect
10
as vacancy left by the photoelectron is filled by an electron from an outer shell, either fluorescence x-rays or Auger electrons may be emitted the probability of x-ray emission is given by the "fluorescent yield" Photoelectric Effect
11
wave interpretation predicts that when electromagnetic radiation is scattered from a charged particle, the scattered radiation will have the same frequency as the incident radiation in all directions the scattering of electromagnetic radiation from a charged particle is viewed as a perfectly elastic billiard ball Compton Scattering
12
4 unknowns: E 1, , K, 3 equations: momentum conservation (2), energy conservation γ Compton Scattering
13
K = (m - m o )c 2 difference between the total energy E of the moving particle and the rest energy E o (at rest) must treat electron relativistically Compton Scattering
14
while for photons energy K =(p 0 – p 1 )c Compton Scattering
15
momentum: Compton Scattering
16
substitute these expressions for K 1, p 2 into relativistic electron energy expression to get (after manipulation): where Δ is the shift that the scattered photon undergoes the wavelength is usually measured in multiples of "Compton units", the ratio of: Compton Scattering
17
wavelength the difference in energy E o - E 1 = K is the kinetic energy of the electron Compton Scattering
18
the min. electron energy corresponds to min. scattered photon energy (θ = 180º) so that this energy K max is called the Compton edge another form for this equation which uses photon energies instead of wavelengths is: Compton Scattering
19
at high incident energies E o the back scattered photon approaches a constant energy Compton Scattering
20
0.511 MeV θ = 90º 0.255 MeV θ = 180º in this limit we find that 0 « ≈, so that the energy: Compton Scattering
21
In a Compton experiment an electron attains kinetic energy of 0.100 MeV when an x-ray of energy 0.500 MeV strikes it. Determine the wavelength of the scattered photon if the electron is initially at rest Compton Scattering Problem
22
in the process of pair production the energy carried by a photon is completely converted into matter, resulting in the creation of an electron-positron pair σ pp ~ Z 2 since the charge of the system was initially zero, 2 oppositely charged particles must be produced in order to conserve charge Pair Production
23
in order to produce a pair, the incident photon must have an energy of the pair; any excess energy of the photon appears as kinetic energy of the particles Pair Production
25
pair production cannot occur in empty space the nucleus carries away an appreciable amount of the incident photon's momentum, but because of its large mass, its recoil kinetic energy, k ≈ p 2 /2m o, is usually negligible compared to kinetic energies of the electron-positron pair thus, energy (but not momentum) conservation may be applied with the heavy nucleus ignored, yielding: h = m + c 2 + m - c 2 = k + + k - + 2m o c 2 since the positron and the electron have the same rest mass; m o = 9.11 x 10 -31 kg Pair Production
26
the inverse of pair production can also occur in pair annihilation a positron-electron pair is annihilated, resulting in the creation of 2 (or more) photons as shown at least 2 photons must be produced in order to conserve energy and momentum Annihilation
27
in contrast to pair production, pair annihilation can take place in empty space and both energy and momentum principles are applicable, so that: where k l is the propagation vector: 2 (k) = 2 / Annihilation
30
problem: how many positrons can a 200 MeV photon produce? the energy needed to create an electron-positron pair at rest is twice the rest energy of an electron, or 1.022 MeV; therefore maximum number of positrons equals: Annihilation
31
absorber nucleus captures a -ray and in most instances emits a neutron: 9 Be( ,n) 8 Be important for high energy photons from electron accelerators cross-sections are « total cross-sections Photodisintegration
32
total attenuation coefficient in computing shielding design the above equation is used this is the fraction of the energy in a beam that is removed per unit distance of absorber Combined Effects
33
the fraction of the beam's energy that is deposited in the absorber considers only the energy transferred by the photoelectron, Compton electron, and the electron pair energy carried away by the scattered photon by Compton and by annihilation is not included Combined Effects
34
Linear Attenuation and Absorption Coefficients for Photons in Water
36
Exponential Absorption due to the different interaction of -rays with matter, the attenuation is different than with α or particles intensity of a beam of photons will be reduced as it passes through material because they will be removed or scattered by some combination of photoelectric effect, Compton scattering and pair production reduction obeys the exponential attenuation law:
37
I = I o e - t where: I 0 = -ray intensity at zero absorber thickness t = absorber thickness I = -ray intensity transmitted = attenuation coefficient if the absorber thickness is measure in cm, then is called linear attenuation coefficient ( l ) having dimensions "per cm" Exponential Absorption
38
if the absorber thickness "t" is measured in g/cm 2, then ( m ) is called mass attenuation coefficient ( m ) having dimensions cm 2 /g where is the density of the absorber Exponential Absorption
39
what percent of an incident x-ray passes through a 5 mm material whose linear absorption is 0.07 mm-1?
40
a monochromatic beam of photons is incident on an absorbing material if the intensity is reduced by a factor of 2 by 8 mm of material, what is the absorption coefficient? Exponential Absorption
41
Half-Value Thickness (HVT) thickness of absorber which reduces the intensity of a photon beam to 1/2 its incident value find HVT of aluminum if = 0.070 mm -1 Exponential Absorption
42
Atomic Attenuation Coefficient a fraction of an incident -ray beam that is attenuated by a single atom, or the probability that an absorber atom will interact with one of the photons where a is referred to as a cross-section and has the units barns Exponential Absorption
43
Linear Attenuation Coefficients
44
what is the thickness of Al and Pb to transmit 10% of a 0.1 MeV -ray? (0.435 cm -1 ) Exponential Absorption
45
if we have a 1.0 MeV - ray: compute the density thickness at 0.1 MeV Exponential Absorption
46
at 1.0 MeV this shows that Pb is only slightly better on a mass basis than Al however for low energy photons Pb is much better in general, for energies between 0.8 5 MeV almost all materials, on a mass basis, have approximately the same -ray attenuating properties Exponential Absorption
49
1-MeV photons are normally incident on a 1- cm lead slab the mass attenuation coefficient of lead (density = 11.35 g/cm 3 ) is 0.0708 cm 2 /g and the atomic weight is 207.2 Photon Interactions - Problem
50
calculate the linear attenuation coefficient what fraction of 1-MeV photons interact in a 1-cm lead slab? what thickness of lead is required for half the incident photons to interact? calculate the mean free path Photon Interactions - Problem
51
Solution a. the linear attenuation coefficient is obtained by multiplying the mass attenuation coefficient by the density = (0.0708 cm 2 g -1 ) (11.35 g cm -3 = 0.804 cm -1. b. if I o photons are incident on the lead slab and I photons penetrate it without interacting, then the fraction not interacting is given by: I/I o = exp[- x] = exp[(-0.804 cm -1 )(1 cm)] = 0.448 Photon Interactions - Problem the fraction of photons interacting is then: 1 - 0.448 = 0.552
52
c.substituting I/I o = 1/2 in eq. (1) above and rearranging yields: x = ln 2 /μ = 0.693/0.804 = 0.862 cm Photon Interactions - Problem
53
d.the mean free path (MFP) is the average distance that an incident photon travels before interaction and is the reciprocal of the attenuation coefficient: MFP = 1/μ = 1/0.804 = 1.24 cm this is also numerically equal to the "relaxation length“ the relaxation length is the shield thickness needed to attenuate a narrow beam of monoenergetic photons to 1/e (= 0.368) of its original intensity and can be derived by substituting I/I o = 1/e Photon Interactions - Problem
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.