Presentation is loading. Please wait.

Presentation is loading. Please wait.

Edited by Mandar More Technical Manager, Ninad`s Research lab Ninad243.weebly.com MODERN OFFICE MANAGEMENT TOOL FOR SELECTIVE DATA.

Similar presentations


Presentation on theme: "Edited by Mandar More Technical Manager, Ninad`s Research lab Ninad243.weebly.com MODERN OFFICE MANAGEMENT TOOL FOR SELECTIVE DATA."— Presentation transcript:

1 Edited by Mandar More Technical Manager, Ninad`s Research lab Ninad243.weebly.com mandar.more@outlook.com MODERN OFFICE MANAGEMENT TOOL FOR SELECTIVE DATA TRANSMISSION TO MULTIPLE USERS

2 ABSTRACT This project is an extremely useful PC based RF communication system management tool in a modern office for data transmission to multiple users. The data is transmitted to multiple users using RF module Receiver section consists of a receiver module which receives the data and feeds to microcontroller which displays the data on a LCD. A buzzer is also interfaced to microcontroller at the receiver side which gives intimation that the data is received.

3 BLOCK DIAGRAM : TRANSMITTER

4 RECEIVER - 1

5 RECEIVER - 2

6 HARD WARE EQUIPMENTS TRANSFORMER (230 – 12 V AC) VOLTAGE REGULATOR (LM 7805) RECTIFIER FILTER MICROCONTROLLER (AT89S52/AT89C51) EEPROM RF MODULE BC547 PUSH BUTTONS LCD IN4007 LED RESISTORS CAPACITORS

7

8 EMBEDDED SYSTEMS Definition for :- EMBEDDED SYSTEMS  A combination of hardware and software which together form a component of a larger machine.  An example of an embedded system is a microprocessor that controls an automobile engine.  An embedded system is designed to run on its own without human intervention, and may be required to respond to events in real time.

9 EMBEDDED SYSTEMS

10 MICRO CONTROLLER  Compatible with MCS®-51 Products  8K Bytes of In-System Programmable (ISP) Flash Memory  4.0V to 5.5V Operating Range  Crystal Frequency 11.0592MHZ  Three-level Program Memory Lock  256 x 8-bit Internal RAM  32 Programmable I/O Lines  Three 16-bit Timer/Counters  Eight Interrupt Sources  Full Duplex UART Serial Channel  Watchdog Timer AT89S52

11 PIN DIAGRAM OF AT89S52

12 LED LEDs are semiconductor devices are made out of silicon. When current passes through the LED, it emits photons as a byproduct. Normal light bulbs produce light by heating a metal filament until its white hot. LEDs present many advantages over traditional light sources including lower energy consumption, longer lifetime, improved robustness, smaller size and faster switching

13  The BC547 transistor is an NPN Epitaxial Silicon Transistor.  The BC547 transistor is a general-purpose transistor in small plastic packages.  It is used in general-purpose switching and amplification BC847/BC547 series 45 V, 100 mA NPN general-purpose transistors.  Whenever base is high, then current starts flowing through base and emitter and after that only current will pass from collector to emitter. BC547

14 The circuit uses HT 12E, HT 12D which are encoder and decoder respectively. 433MHz ASK transmitter and receiver is used for the remote control. RF remote control

15 Range in open space(Standard Conditions) : 100 Meters RX Receiver Frequency : 433 MHz RX Typical Sensitivity : 105 Dbm RX Supply Current : 3.5 mA RX IF Frequency : 1MHz Low Power Consumption Easy For Application RX Operating Voltage : 5V TX Frequency Range : 433.92 MHz TX Supply Voltage : 3V ~ 6V TX Out Put Power : 4 ~ 12 Dbm Features of RF

16 LIQUID CRYSTAL DISPLAY (LCD)  Most common LCDs connected to the microcontrollers are 16x2 and 20x2 displays.  This means 16 characters per line by 2 lines and 20 characters per line by 2 lines, respectively.  The standard is referred to as HD44780U, which refers to the controller chip which receives data from an external source (and communicates directly with the LCD.

17 LCD BACKGROUND  If an 8-bit data bus is used the LCD will require 11 data lines (3 control lines plus the 8 lines for the data bus)  The three control lines are referred to as EN, RS, and RW  EN=Enable (used to tell the LCD that you are sending it data)  RS=Register Select (When RS is low (0), data is treated as a command) (When RS is High(1), data being sent is text data )  R/W=Read/Write (When RW is low (0), the data written to the LCD) (When RW is high (1), the data reading to the LCD)

18 SOFTWARE REQUIREMENTS PROGRAMMING LANGUAGES Embedded C, ALP (Assembly Language) COMPILERS: Keil 2.0/3.0uv DUMPING SOFT WARE: Using Micro controller flash Software we are dumping our HEX Code into Micro Controller

19 KEIL COMPILER WINDOW

20 BIBILOGRAPHY  The 8051 Microcontroller and Embedded systems” by Muhammad Ali Mazidi and Janice Gillispie Mazidi, Pearson Education.  ATMEL 89S52 Data Sheets.  www.atmel.com  www.beyondlogic.org  www.wikipedia.org  www.howstuffworks.com  www.alldatasheets.com

21 THANK ‘Q’


Download ppt "Edited by Mandar More Technical Manager, Ninad`s Research lab Ninad243.weebly.com MODERN OFFICE MANAGEMENT TOOL FOR SELECTIVE DATA."

Similar presentations


Ads by Google