1. PVSS Installation of a Project Need to run this by Xiaofeng to make sure the steps are right

2. Assumes PVSS installed Current patch shouldn’t be later than July 08, because there were problems with the DB since then. I don’t use the DB, so it doesn’t matter much, but…

3. Get Framework Install framework in PVSS as specified Get fwInstallation package and save Use a separate directory from the ETM tree

4. Unpack your project into a folder

5. Run PVSS, request new project

6. Standard is OK

7. Tell it the project name Browse for the folder

8. Create new folder

9. Project Name doesn’t have to be the same as the folder name

10. General Settings are OK

11. Wait for a few minutes

12. And acknowledge the OK

13. New Project appears

14. Unpack fwInstallation package: Next slide

15. into subfolder of project

16. Start Project You click on the project Put the mouse over the “start project” icon Click when the icon turns green (a few seconds)

17. Next Log Viewer, Gedi, and PVSS Console appear In Gedi, start the Installer as shown in the next slide

18. Gedi

19. From subfolder fwInstallation

20. fwInstallation.pnl

21. SOME Framework versions! Asks for a directory to install in: invents a name. OK

22. SOME Framework versions! Wants a DB connection. I DON’T USE THIS: NO

23. Framework Installation Panel Browse for folder

24. Select folder

25. Select Components Click on components you need Then click Install

26. Select installation directory Suggested is OK Click OK

27. Click Install again on Framework Installation Panel! I don’t know why Some Framework versions only

28. Click OK for installation

29. Project will have to restart This takes a few minutes

30. Windows will complain Make sure you unblock everything it complains about. I use DIM, and Windows firewall wants to make sure that’s all right with me.

31. Now run the fwInstallation Panel again See previous slides – Gedi – fwInstallation – fwInstallation.pnl

32. Install your project

33. Select Install Click Install at the bottom of the list

34. OK to verification panel

35. Project will have to restart This takes a few minutes

36. Fiddle with your new project as needed In my case I need to change the DIM DNS server