1. Introduction to
ARIA IP - 60
Anton Hattingh

2. Content System overview Connection diagram System Recourses
Connections
Hardware
Features

3. System overview
Hybrid telephone system with 12 analog PSTN’s & 48 ext. Caller ID service for CO line & SLT Conference, SMDR, LCR, Call duration control Collect call barring, Mobile extension Other services for enterprise communications - Alarm detection - External door phone control - External paging interface, - External music source interface

4. General connection diagram

5. System Resources 1/2 DESCRIPTION CAPACITY/BOARD TOTAL Time Slots 128
CO Line Ports
3/MBU, 3/EMBU, 3/CHB308, 3/CSB316, 8/VOIB, 30/E1HB8
Max. 36
Max Direct Station (DKT, SLT, DSS) Connections
8/MBU, 8/EMBU, 8/CHB308, 16/CSB316, 8/VOIB, 8/E1HB8
Max. 48
Max. Door
2/MBU, 2/EMBU 4
LAN
MBU, VOIB, E1HB8 3
MODEM Channel
1/MODU 1
Attendant Positions
5/System
Intercom Links
Non-Blocking
Paging - All Call
- Internal
1 zone
5 zones
Station Speed Dial
100/station, 24 digits each
500
System Speed Dial
24 digits each
Last Number Redial
15 ~ 50(by admin programming)
32 digits

6. System Resources 2/2 DESCRIPTION CAPACITY/BOARD TOTAL CO Line Group 8
Station Group 10
Conference
3~15 Party
All ports are available
Multi-Conference
Max. 3 groups
Internal MOH (13 Music Sources)
1/MBU 1
External MOH
External Paging port
External Relay Contact
2/MBU, 2/EMBU 4
Alarm Input
RS-232C Port
DTMF/CPT Receiver channels
16 chs/MBU
16 chs
FSK Receiver channels
PFT Circuit
1/MBU, 1/EMBU, 1/CHB308, 1/CSB316

7. MBU connectors and LED Status LED LD1 : System running indication
※ Available Option:
1. CN2 : E1HB8, CHB308, CSB316 or SLIB8
2. CN4 : MODU
3. CN5 : VMIU or AAFU
4. CN14: VOIB
5. CN9 & CN10: CMU50PR or CMU12PR
LD1 : System running indication
LD2-4 : S/W task indication
SW1 : Default ON
Pole1 : reserved
Pole2 : system trace on
Pole3 : reserved
Pole4 : system backup
SW2 : Backup battery
ON for protection
Status LED

8. System Connections BKSU EKSU BKSU Only RJ-11 CO# : Loop start CO Port
1: N/A
2: DKT-Tip
3: SLT-Tip or CO-Tip
4: SLT-Ring or CO-Ring
5: DKT-Ring
6: N/A
CO# : Loop start CO Port
STA# : Hybrid Port
DKT# : DKTU Only Port
SLT# : SLT Only Port
BKSU
EKSU
BKSU Only

9. Connector Pin-out 1/3 MBU (CO) MBU (Extension) DKT ONLY MBU (Hybrid)
PIN Number NO
Signal Name
RJ11
1,2
N/A
3,4
CO-T, CO-R
5,6
MBU (Extension) DKT ONLY
CONNECTOR
PIN NUMBER NO
SIGNAL NAME
RJ11 1
N/A 2
DKT-T
3,4
ALARM_Detection 5
DKT-R 6
MBU (Hybrid)
CONNECTOR
PIN NUMBER NO
SIGNAL NAME
RJ11 1
N/A 2
DKT-T
3,4
SLT-T, SLT-R 5
DKT-R 6
NOTE—When installing DKT or SLT on Hybrid Ports, (MJ2-2,3,4,5,6,7,8),
keep the above pin assignment. Otherwise the DKT or SLT will not operate normally.

10. Connector Pin-out 2/3 TERMINAL DKT TERMINAL SLT CONNECTOR PIN NUMBER
SIGNAL NAME
RJ11 1
N/A 2
RING
3,4
Reserved 5
TIP 6
TERMINAL SLT
CONNECTOR
PIN NUMBER NO
SIGNAL NAME
RJ11
1,2
N/A
3,4
TIP, RING
5,6

11. Connector Pin-out 3/3 CN13 Pin Assignment (Relay Contact)
SIGNAL NAME
4 PIN 1
Relay 1-pin1 2
Relay 1-pin2 3
Relay 2-pin1 4
Relay 2-pin2
MJ3 Pin Assignment (LAN)
Connector
Pin Number NO
SIGNAL NAME
FUNCTION
RJ45
4,5,7,8
RESERVED 1
TX+
Transmit Data 2
TX- 3
RX-
Receive Data 6
RX+

12. Terminal/SLT Cabling Distance

13. Expansion Card CHB308 CO Line and Hybrid Board (3 CO + 8 HYB)
External.
Provides 3 circuits Loop start CO line interface.
DTMF or pulse signaling to line
Loop current detection
FSK & DTMF CID detection.
Call progress tone detections
Internal.
Provides 8 digital Stations or 8 SLT station circuits.
FSK & DTMF CID detection and Generator.
+36V Power Circuit for SLT feeding
SLT feeding Current is 20mA at 900ohm loop impedance.

14. Expansion Card CSB 316 CO Line and SLT Board (3 CO + 16 SLT) External.
Provides 3 circuits Loop start CO line interface.
DTMF or pulse signaling to line
Loop current detection
FSK & DTMF CID detection.
Call progress tone detections.
Internal.
Provides 16 SLT station circuits.
FSK & DTMF CID detection and Generator.
+36V Power Circuit for SLT feeding
SLT feeding Current is 20mA at 900ohm loop impedance.

15. Expansion Card SLIB 8 SLT Board (8 SLT’s) Internal.
Provides 8 SLT station circuits.
FSK & DTMF CID detection and Generator.
+36V Power Circuit for SLT feeding
SLT feeding Current is 20mA at 900ohm loop impedance.

16. E1 Digital trunk & 8 Hybrid
Expansion Card E1HB8
E1 Digital trunk & 8 Hybrid
CN5 on the MBU, but not on the EMBU
E1 digital trunk: maximum 30 CO lines at the same time
8 Hybrid ports that provide DKT or SLT connection
2.048Mbps E1 line as CAS(Channel Associated Signaling)
HDB3 CODE
DID, DOD, and TIE according to each country’s specifications
Pulse dialing, DTMF dialing, and MFC-R2 signaling(30 channels at the same time)
SLU8(Single Line Interface Unit: 8 ports
CN6, CN7 on the E1HB8
+36V power circuit for SLT feeding
Single Line Interface circuit: 8 EA

17. Add on board MODU Modem function board MODEM function board
  MODU provides analogue modem connection.
MODU should be installed on the CN4
Supports Bell, ITU-T, V.34, V.32BIS, V.90 Protocol
300bps up to 33Kbps speed rate
Automatic rate negotiation

18. Voice Mail Interface Unit
Add on board VMIU
Voice Mail Interface Unit
VMIU provides 4 channel Record/Play
VMIU provides Time & System prompt
All message are saved in Flash memory
Max record time
- Prompt : 8 Min.
- System greeting : 24 Min
- User record time : 99 Min
Max. Number of User Voice Message: 800ea
Note : User Greeting does not lost by system power off or reset
because of this message is stored in FLASH memory

19. Auto Attendant Function Unit
Add on board AAFU
Auto Attendant Function Unit
AAFU provides 4 channel Record/Play
AAFU provides Time & System prompt
All message are saved in Flash memory
Max record time
- Prompt : 8 Min.
- System greeting : 24 Min
- User record time : 9 Min
Max. Number of User Voice Message: 800ea
Note : User Greeting does not lost by system power off or reset
because of this message is stored in FLASH memory

20. Voice over Internet Protocol Interface board
Add on board VOIB & VOIU
Voice over Internet Protocol Interface board
VOIB can be installed on the basic MBU
Provides the Ethernet interface for S/W applications and VoIP features .
Optional VoIP daughter board.(VOIU)
Maximum Capacity: 8 channels
-VOIB provides four(4) VoIP channels.
-VOIU provides four(4) VoIP channels.
Item
Specification
LAN Interface
10 / 100 Base-T Ethernet(IEEE 802.3)
Speed
10 Mbps (Auto-Negotiation)
Duplex
Half Duplex or Full Duplex(Auto-Negotiation)
VoIP Protocol
H.323 Revision 2
Voice Compression
G.711/G.726/G729/G.723.1
Voice/Fax Switching
T.38
Echo cancellation
G.165

21. Add on board CMP50PR & CMU12PR
Call Metering & Polarity Reversal Detection unit 50Hz and 12Hz
CMU50PR (Call Metering-50 Hz & Polarity Reversal Detection unit)
Provides 3 channels Call Metering detection for 50Hz
Provides 3 channels of Polarity Reversal Detection
It can be installed on the MBU, EMBU, CHB308 or CSB316
CMU12PR(Call Metering-12KHz & Polarity Reversal Detection unit)
Provides 3 channels Call Metering detection for 12 KHz or 16Khz
Provides 3 channels of Polarity Reversal

22. Not Compatible with OptiCon IP and GDK Systems.
Proprietary Terminals
MODEL
DESCRIPTION
LDP-7224D
3 Line LCD display, 24 Flexible Button,3 Soft keys, Navigation key
LDP-7208D
2 Line LCD Display, 8 Flexible Button
LDP-7248DSS
48 Button DSS Console
LDP-DPB
Door Phone Box
LDP-7224D
LDP-7208D
LDP-7248DSS
LDP-Door phone
Not Compatible with OptiCon IP and GDK Systems.

23. IP Terminals MODEL DESCRIPTION LIP-7024LD LIP-7024D LIP-7016D
3 Line LCD display, 24 Flexible Button,3 Soft keys, Navigation key,
Dual LED,Calender,Scheduler
LIP-7024D
Dual LED
LIP-7016D
3 Line LCD display, 16 Flexible Button,3 Soft keys, Navigation key,
LIP-7008D
2 Line LCD Display, 8 Flexible Button
LIP-7024LD
LIP-7024D
LIP-7016D
LIP-7008D

24. Maintenance
PSTN
Dial-up
Connection
Off-site (Remote)
Maintenance
Data
Network
In-site
maintenance
Digital Terminal
Admin
Console
On-site & Off site maintenance through RS-232C, Ethernet, Modem
On line PC Admin
: DB up/download, Diagnostics, S/W upgrade, PC Admin
Off line PC Admin (PC Admin Pro)
Speed Editor for system speed dial
User level admin program – adjustable level program

25. Voice Mail / Auto Attendant
Optional Voice Mail and Auto-Attendant
Auto-Attendant : 4 channels / 10 min recording / 25 min system greeting
Voice Mail
SMS Notification to virtual extension (mobile extension)
4 ch. / Max. 100 min recording time/ 25 min greeting / 800 user message recording
Max. 100 system greetings / Max. 25 min

26. Networking Business models for SIP operator / Nortel IP platform
SIP / H.323 proxy registration
ARIA IP – 60 Voice Networking

27. Questions?