1. Floor Warming

2. 2 RaySol System

3. 3 RaySol Applications Freezer Frost Heave Prevention Concrete Floor Warming Heat Loss Replacement Tile and Marble Floor Warming

4. 4 Application Overview – Not primary heat source - comfort heat – Residential bathrooms – Embedded in mortar under tile – Low density concrete (Gypcrete) often used

5. 5 Heat Loss Replacement Application Overview – Used in areas over unheated space such as parking garage – Objective is to have net zero heat flux – Run in conduit or attached to bottom of floor

6. 6 Concrete Floor Warming Application overview – Not primary heat source - comfort heat – Schools, gymnasiums, bathrooms – Run in conduit

7. 7 Frost Heave Prevention Application Overview – Moisture in ground under cold storage areas (<32 degrees) freezes forcing up floors – Insulation slows, but does not prevent, freezing

8. 8 RaySol Installation Methods Embedded in mortar In conduit embedded in concrete In conduit embedded in subsoil Attached to the bottom of concrete floor

9. 9 Tyco Thermal Controls Solution Self-regulating heating cable – RaySol 1 and RaySol 2 Components – FTC-XC, FTC-P -- Power connections – RayClic-E -- End Seal Design Software – Automated design guide (RS-ADG) Literature – Design guide – Installation and operation manual – Installation instructions

10. 10 Define the Application Each section of the design Guide is a Unit

11. 11 Select the Heating Cable Spacing Use the proper table to select spacing and determine amount of heating cable required.

12. 12 Heating Cable Layout Determine the heating cable and component layout for your application.

13. 13 Design the Electrical System Use the maximum circuit length to determine the number of circuits required.