1. SB-CMS-PIR - ceiling mounted PIR sensor

2. Subnet ID and Device ID Device Remark Change the ID if needed

3. e.g., you can enable/disable the PIR sensor in HDL-BUS Pro software, you can also send UV switch 253-ON to enable it, or send UV switch 253-OFF to disable it.

4. Combine logic inputs Select logic relation Set logic output better to set some delay time, e.g., 10s.

5. Enable the security function of ch1 Assign ch1 to the security module(3/80) and security area (1).

6. Simulate some sensor value or status. This is very useful when to test the new-created function.

7. application Please refer to the 12in1 sensor