1. Electrical stations, switch rooms and server rooms
Raised Access Floors
Electrical stations, switch rooms and server rooms

2. Raised Floor Pedestals
Head plate
For screwing of panels and stringers
For fixing of the pedestal bracing
For fixing of the gasket
For fixing of the gasket
Fixing of standard stringer
Hole for locking glue

3. Reinforcement profiles
Overview CL
41 x 40 x 1 CM
84 x 40 x 1.7 CH
126 x 40 x 2 CS
41 x 40 x 1.7
Profile dimensions

4. C – Profiles Advantages: Easy installation
Huge time saving with spring clip installation
Standard range of pedestals
Product is protected by utility patent

5. High Strength Reinforcement Profiles Fixing
Variant 1:
Install spring clip from below into the slot
Turn of 90° clockwise
Also with deinstallation!

6. High Strength Reinforcement Profiles Fixing
Variant 2:
Install hammer head screw
from below into the slot
Rotate screw 90° and tighten it

7. High Strength Reinforcement Profiles Panel support
Fixing gasket:
Support of the raised floor panels
Fixing gasket with four noppes for supporting the corners of the panel

8. High Strength Reinforcement Profiles Parallel and cross connectors
Connection of reinforcement profiles:
Cross connector:
- Connection on the reinforcement profile with drilling screws
- Connection of the crossing reinforcement profile with drilling screws

9. High Strength Reinforcement Profiles Parallel and cross connectors
Connection of reinforcement profiles:
Parallel connector:
- Connection on the reinforcement profile with drilling screws
- Connection of the additional
reinforcement profile with drilling screws

10. Reinforcement profiles

11. Switchgear Construction for Server / Control Rooms
Installation frame
Panel
Reinforcement profile
System solution:
Placing of the pedestals (grid acc. to plan)
Installation of the reinforcement profiles regardless the later position of the control resp. Server cabinets
Mounting of a installation frame:
Support structure for later installations
Position of the frame anywhere possible
Keeping of the floor grid by displacing the installation frame by the half of the switchgear width
- No cut panels necessary with the positioning of the installation frame in the grid

12. Switchgear construction Later conversion
Flexibility with change of use:
Replacing of switchgear cabinet / server is easily possible
Replacing of the installations in the panel grid:
- Replacing of the installation frame in a different grid field
- Closing of the previous opening with the panel which were taken out of the new opening
- Replacing and cabling of the equipment

13. Switchgear construction Later conversion
Flexibility with change of use:
- Replacing of the installation frame in any desired position regardless the panel grid
- Fixing of the installation frame with cross resp. longitudinal connectors
- Closing of the previous opening with the panel which were taken out of the new opening
- If necessary, cut panels have to be supported with additional reinforcement profiles
- Replacing and cabling of the equipment

14. Switch Room Construction
for server rooms / switch rooms
Application area:
With high loads
In computer centres or switch rooms
With high construction heights of the system floors
With dynamic loads

15. Thank you for your attention!