1. InsulCorr
INSULCORRTM is a high build single component multi polymer acrylic resin matrix coating
Incorporates insulating, blocking and reflective agents to reduce the transfer of heat
Designed to provide an economical and fast turnaround approach to thermal insulation
Insulating complex components becomes seamless and simple

2. Ceramic Science at Work

3. Industrial Insulative Coatings
Personnel Protection - used to lower substrate temperatures within safe to touch guidelines
Heat exchanger protection - used for personnel protection
Boiler protection and heat retention - used to protect personnel and provide more efficiency for boilers
HVAC - used to control and eliminate condensation in plant areas
Rooftops - used to reduce and seal rooftops from weather and radiant heat gain
Tanks - used to reduce thermal shock, increase control condensation and for heat or cold retention
Piping - used to insulate pipes and provide substrate protection
Substrate protection and insulation - used in various industrial equipment to help insulate equipment against radiant heat gain
Cold boxes - used to help insulate and reduce/eliminate condensation

4. Application Single component Water based Low to no odor
Mix with mud mixer before use (do not over mix)
Brush, roller, spray (min 33:1 airless)
First coat mist coat application
Subsequent coats are applied in multiple thin passes 10 mil (dft) per pass

5. Service Exposure
Max temperature rating 400 oF (205 oC) intermittent up to 500 oF (260 oC)
For higher temperature glass mat/adhesive system top coated with InsulCorr can be applied
Primer is required for temperatures above oF (120 oC)
For added corrosion protection primer is recommended

6. Personal Protection
InsulCorr’s cool to touch effect will safeguard employees from hot surface contact
Cool to touch is a result of the lower thermal inertia and heat transfer properties
ASTM C1055 defines safe to touch of a heated surface as the effect on skin contact after 5 seconds of exposure
At temperatures above the maximum safe to touch quantification temperature of 140 oF per ASTM the InsulCorr coating remains cool to touch

7. Safe to Touch Temperature
With exposure to metallic substrates above 70°C, the rate of injury from a high capacity surface exceeds the body reaction time (less than 1 s to have completed epidermis cell death) such that the blood vessel location or flow has little effect on the level of burn

8. Exposure Zone
Exposures below the lower curve should not produce permanent injury in normal humans.
Exposures between the curves are described as second-degree burns and have intermediate levels of cell damage.
Exposures at levels above the top line are defined as third-degree burns that cause deep, permanent cell damage and scarring.

9. InsulCorr
Coating
Thermocouple
Hotplate
¼” Plate
Plate

13. Furnace Mineral Products Inc.
7065 Tranmere Dr, Ste 6
Mississauga, ON, L5S 1M2 –
Website –
Phone –
Follow us