1. 5: DataLink Layer5-1 Chapter 5 Link Layer and LANs Part 3: MAC Computer Networking: A Top Down Approach 6 th edition Jim Kurose, Keith Ross Addison-Wesley March 2012

2. 5: DataLink Layer5-2 Link Layer r 5.1 Introduction and services r 5.2 Error detection and correction r 5.3Multiple access protocols r 5.4 Link-layer Addressing r 5.5 Ethernet r 5.6 Link-layer switches r 5.7 PPP r 5.8 Link virtualization: MPLS r 5.9 A day in the life of a web request

3. 5: DataLink Layer5-3 Multiple Access Links and Protocols Two types of “links”: r point-to-point m PPP for dial-up access m point-to-point link between Ethernet switch and host r broadcast (shared wire or medium) m old-fashioned Ethernet m upstream HFC m 802.11 wireless LAN shared wire (e.g., cabled Ethernet) shared RF (e.g., 802.11 WiFi) shared RF (satellite) humans at a cocktail party (shared air, acoustical)

4. 5: DataLink Layer5-4 Multiple Access protocols r single shared broadcast channel r two or more simultaneous transmissions by nodes: interference m collision if node receives two or more signals at the same time multiple access protocol r distributed algorithm that determines how nodes share channel, i.e., determine when node can transmit r communication about channel sharing must use channel itself! m no out-of-band channel for coordination

5. 5: DataLink Layer5-5 Ideal Multiple Access Protocol Broadcast channel of rate R bps 1. when one node wants to transmit, it can send at rate R. 2. when M nodes want to transmit, each can send at average rate R/M 3. fully decentralized: m no special node to coordinate transmissions m no synchronization of clocks, slots 4. simple

6. 5: DataLink Layer5-6 MAC Protocols: a taxonomy Three broad classes: r Channel Partitioning m divide channel into smaller “pieces” (time slots, frequency, code) m allocate piece to node for exclusive use r Random Access m channel not divided, allow collisions m “recover” from collisions r “Taking turns” m nodes take turns, but nodes with more to send can take longer turns

7. 5: DataLink Layer5-7 Channel Partitioning MAC protocols: TDMA TDMA: time division multiple access r access to channel in "rounds" r each station gets fixed length slot (length = pkt trans time) in each round r unused slots go idle r example: 6-station LAN, 1,3,4 have pkt, slots 2,5,6 idle 1 3 4 1 3 4 6-slot frame

8. 5: DataLink Layer5-8 Channel Partitioning MAC protocols: FDMA FDMA: frequency division multiple access r channel spectrum divided into frequency bands r each station assigned fixed frequency band r unused transmission time in frequency bands go idle r example: 6-station LAN, 1,3,4 have pkt, frequency bands 2,5,6 idle frequency bands time FDM cable

9. 5: DataLink Layer5-9 Random Access Protocols r When node has packet to send m transmit at full channel data rate R. m no a priori coordination among nodes  two or more transmitting nodes ➜ “collision”, r random access MAC protocol specifies: m how to detect collisions m how to recover from collisions (e.g., via delayed retransmissions) r Examples of random access MAC protocols: m slotted ALOHA m ALOHA m CSMA, CSMA/CD, CSMA/CA

10. 5: DataLink Layer5-10 Slotted ALOHA Assumptions: r all frames same size r time divided into equal size slots (time to transmit 1 frame) r nodes start to transmit only slot beginning r nodes are synchronized r if 2 or more nodes transmit in slot, all nodes detect collision Operation: r when node obtains fresh frame, transmits in next slot m if no collision: node can send new frame in next slot m if collision: node retransmits frame in each subsequent slot with prob. p until success

11. 5: DataLink Layer5-11 Slotted ALOHA Pros r single active node can continuously transmit at full rate of channel r highly decentralized: only slots in nodes need to be in sync r simple Cons r collisions, wasting slots r idle slots r nodes may be able to detect collision in less than time to transmit packet r clock synchronization

12. 5: DataLink Layer5-12 Slotted Aloha efficiency r suppose: N nodes with many frames to send, each transmits in slot with probability p r prob that given node has success in a slot = p(1-p) N-1 r prob that any node has a success = Np(1-p) N-1 r max efficiency: find p* that maximizes Np(1-p) N-1 r for many nodes, take limit of Np*(1-p*) N-1 as N goes to infinity, gives: Max efficiency = 1/e =.37 Efficiency : long-run fraction of successful slots (many nodes, all with many frames to send) At best: channel used for useful transmissions 37% of time! !

13. 5: DataLink Layer5-13 Pure (unslotted) ALOHA r unslotted Aloha: simpler, no synchronization r when frame first arrives m transmit immediately r collision probability increases: m frame sent at t 0 collides with other frames sent in [t 0 -1,t 0 +1]

14. 5: DataLink Layer5-14 Pure Aloha efficiency P(success by given node) = P(node transmits). P(no other node transmits in [p 0 -1,p 0 ]. P(no other node transmits in [p 0 -1,p 0 ] = p. (1-p) N-1. (1-p) N-1 = p. (1-p) 2(N-1) … choosing optimum p and then letting n -> infty... = 1/(2e) =.18 even worse than slotted Aloha!

15. 5: DataLink Layer5-15 CSMA (Carrier Sense Multiple Access) CSMA: listen before transmit: If channel sensed idle: transmit entire frame r If channel sensed busy, defer transmission r human analogy: don’t interrupt others!

16. 5: DataLink Layer5-16 CSMA collisions collisions can still occur: propagation delay means two nodes may not hear each other’s transmission collision: entire packet transmission time wasted spatial layout of nodes note: role of distance & propagation delay in determining collision probability

17. 5: DataLink Layer5-17 CSMA/CD (Collision Detection) CSMA/CD: carrier sensing, deferral as in CSMA m collisions detected within short time m colliding transmissions aborted, reducing channel wastage r collision detection: m easy in wired LANs: measure signal strengths, compare transmitted, received signals m difficult in wireless LANs: received signal strength overwhelmed by local transmission strength r human analogy: the polite conversationalist

18. 5: DataLink Layer5-18 CSMA/CD collision detection

19. Link Layer5-19 Ethernet CSMA/CD algorithm 1. NIC receives datagram from network layer, creates frame 2. If NIC senses channel idle, starts frame transmission. If NIC senses channel busy, waits until channel idle, then transmits. 3. If NIC transmits entire frame without detecting another transmission, NIC is done with frame ! 4. If NIC detects another transmission while transmitting, aborts and sends jam signal 5. After aborting, NIC enters binary (exponential) backoff: m after mth collision, NIC chooses K at random from {0,1,2, …, 2 m -1}. NIC waits K · 512 bit times, returns to Step 2 m longer backoff interval with more collisions

20. Link Layer5-20 CSMA/CD efficiency r T prop = max prop delay between 2 nodes in LAN r t trans = time to transmit max-size frame r efficiency goes to 1 m as t prop goes to 0 m as t trans goes to infinity r better performance than ALOHA: and simple, cheap, decentralized !

21. 5: DataLink Layer5-21 “Taking Turns” MAC protocols channel partitioning MAC protocols: m share channel efficiently and fairly at high load m inefficient at low load: delay in channel access, 1/N bandwidth allocated even if only 1 active node! Random access MAC protocols m efficient at low load: single node can fully utilize channel m high load: collision overhead “taking turns” protocols look for best of both worlds!

22. 5: DataLink Layer5-22 “Taking Turns” MAC protocols Polling: r controller node “invites” client nodes to transmit in turn r typically used with “dumb” client devices r concerns: m polling overhead m latency m single point of failure (controller) controller clients poll data

23. 5: DataLink Layer5-23 “Taking Turns” MAC protocols Token passing: r control token passed from one node to next sequentially. r token message r concerns: m token overhead m latency m single point of failure (token) T data (nothing to send) T

24. cable headend CMTS ISP cable modem termination system  multiple 40Mbps downstream (broadcast) channels  single CMTS transmits into channels  multiple 30 Mbps upstream channels  multiple access: all users contend for certain upstream channel time slots (others assigned) Cable access network cable modem splitter … … Internet frames,TV channels, control transmitted downstream at different frequencies upstream Internet frames, TV control, transmitted upstream at different frequencies in time slots

25. Link Layer5-25 DOCSIS: data over cable service interface spec  FDM over upstream, downstream frequency channels  TDM upstream: some slots assigned, some have contention  downstream MAP frame: assigns upstream slots  request for upstream slots (and data) transmitted random access (binary backoff) in selected slots MAP frame for Interval [t1, t2] Residences with cable modems Downstream channel i Upstream channel j t1t1 t2t2 Assigned minislots containing cable modem upstream data frames Minislots containing minislots request frames cable headend CMTS Cable access network

26. 5: DataLink Layer5-26 Summary of MAC protocols r channel partitioning, by time, frequency or code m Time Division, Frequency Division r random access (dynamic), m ALOHA, S-ALOHA, CSMA, CSMA/CD m carrier sensing: easy in some technologies (wire), hard in others (wireless) m CSMA/CD used in Ethernet m CSMA/CA used in 802.11 r taking turns m polling from central site, token passing m Bluetooth, FDDI, IBM Token Ring