1. Isolation of hydrolysing Linamarase enzyme from cassava root peel
Equipment
Reagents
Test tubes
Graduated cylinder
Pipets
Balance
Centrifuge (ultracentrifuge)
Filtration devices (including ultra filters)
0.45microm membrane pore
Saturated (NH4)2SO4 solution.
0.1M acetate buffer(pH 5.5)
0.1M phosphate buffered saline PBS

2. Procedure
Dice peel into small pieces and blend together for 8 mins in 300mL of acetate buffer to avoid damage of structure
Macro molecules are removed by filtering to remove debris
Ultracentrifuge is used to spin solution at 10,000 rpm for 30mins
More dense molecules migrate away from axis of centrifuge and less dense move towards axis.

3. Procedure The supernatant is carefully decanted out or pipetted out.
The saturated ammonium sulphate is then added continually for salting-out process. This causes the enzymes to ppt-out
The ppt is dissolved in 50mL PBS and was dialysed(via porous cellulose tubing to remove remaining salt) using the membrane pore size.
For further purification, the supernatant is spun two more times with a progressive higher speed and 0.2um membrane(ultrafiltration) is used and components like linamarin permeated out while the pure enzyme which could not pass through is collected as the retentate.
The enzyme will be stored below 4oC to avoid denaturation.

4. Isolation of linamarin from cassava
Equipment and materials
Reagents
Bulk cassava roots
Ultra filter of membrane size of 0.2um
Blender
Picrate paper
Industrial mill bag
Plastic bucket
evaporator
Boiling methanol

5. Procedure
100g cassava root is diced and blended together in boiling methanol(99.5%)
Using the mill bags, squeeze out the solution for about an hour in a plastic bucket
Solution settles and clear supernatant is decanted
It is then followed by ultrafiltration using 0.2um set
The isolated linamarin mixture is then evaporated with an evaporator set at 45oC
A dark brown jelly-like solid was recovered.
The linamarin presence is tested with a picrate paper.
The linamarin is impure and needs purification.

6. Ultrafiltration: membrane technology
Separation of components from a solution with mixed molecule sizes by flowing the solution under very high pressure over the surface of a membrane.
The cut-off for ultrafiltration systems is ,000 MW.
The molecular weight of linamarin is 235.4MW.
The cross-flow membrane is preferred to the dead-end flow because it has less tendencies of feed fouling or concentration polarization.

7. Purification of linamarin: Adsorption Process
80g of isolated and evaporated CCE is dissolved in 250mL distilled water
The solution is then introduced into 80g of ATC in a Pyrex conical flask
A shaking incubator is used on it at 190rpm at 25oC
Solution turns colourless after filtering with 185mm filter paper supported with vacuum pump.
After each contact time, 4mL filtrate is added to 11mL lis. Solution
Colourless solution obtained is dry frozen with liquid nitrogen to form white granules

8. Model: In Vitro Evaluation(expected results)
HL-60 cells are exposed to only purified linamarin(conc of 300ug/mL) without lis showed a reduction in cell growth by 60%
With the addition of lis of conc 150ug/mL, cell viability will reduce in excess of 90% is seen.

9. References
1)Iyuke, S. E., Yusuf, U. F., Razil, R., Fakhuru, A. I.,Billa, N and Achike, F. I. (2004). Antitumoral action of linamarin and cassava tissue extracts: Engineering for life. The7th World Congress of Chemical Engineering, Scotland, 140, )Link, N., Aubel, C., Kelm, J. M., Marty, R.R., Greber, D., Djovo, V., Bourhis, J., Weber, Wand Fussenegger, M. (2006). Therapeutic protein transduction of mammalian cells andmice by nucleic acid-free lentiviral nanoparticles, Nuclei Acid Research 43 (2) e16-e16. 3)Mantell, C. L. (1951). Adsorption. 2nd Ed., McGraw-Hill Book Company, Inc, USA pp )Norzilah, B. A. (2005). Adsorption of 4-nitrophenol onto palm shell based activated carbon.Thesis, Department of Chemical Engineering, University of Malaya, Kuala Lumpor,Malaysia. Pp 11. 5) Ralph, T. Y. (2003). Adsorbents: fundamentals and application. John Wiley & Sons, Inc.,Publication, Hoboken, New Jersey. Pp