1. Angelo Farina Dip. di Ingegneria Industriale - Università di Parma Parco Area delle Scienze 181/A, 43100 Parma – Italy angelo.farina@unipr.it www.angelofarina.it ACOUSTICS part – 3 Sound Engineering Course

2. Frequency analysis

3. Sound spectrum The sound spectrum is a chart of SPL vs frequency. Simple tones have spectra composed by just a small number of spectral lines, whilst complex sounds usually have a continuous spectrum. a)Pure tone b)Musical sound c)Wide-band noise d)White noise

4. Time-domain waveform and spectrum: a)Sinusoidal waveform b)Periodic waveform c)Random waveform

5. Analisi in bande di frequenza: A practical way of measuring a sound spectrum consist in employing a filter bank, which decomposes the original signal in a number of frequency bands. Each band is defined by two corner frequencies, named higher frequency f hi and lower frequency f lo. Their difference is called the bandwidth f. Two types of filterbanks are commonly employed for frequency analysis: constant bandwidth (FFT); constant percentage bandwidth (1/1 or 1/3 of octave).

6. Constant bandwidth analysis: narrow band, constant bandwidth filterbank: f = f hi – f lo = constant, for example 1 Hz, 10 Hz, etc. Provides a very sharp frequency resolution (thousands of bands), which makes it possible to detect very narrow pure tones and get their exact frequency. It is performed efficiently on a digital computer by means of a well known algorithm, called FFT (Fast Fourier Transform)

7. Constant percentage bandwidth analysis: Also called octave band analysis The bandwidth f is a constant ratio of the center frequency of each band, which is defined as: f hi = 2 f lo 1/1 octave f hi = 2 1/3 f lo 1/3 octave Widely employed for noise measurments. Typical filterbanks comprise 10 filters (octaves) or 30 filters (third-octaves), implemented with analog circuits or, nowadays, with IIR filters

8. Nominal frequencies for octave and 1/3 octave bands: 1/1 octave bands 1/3 octave bands

9. Octave and 1/3 octave spectra: 1/3 octave bands 1/1 octave bands

10. Narrowband spectra: Linear frequency axis Logaritmic frequency axis

11. White noise and pink noise White Noise: Flat in a narrowband analysis Pink Noise: flat in octave or 1/3 octave analysis

12. Critical Bands (BARK): The Bark scale is a psychoacoustical scale proposed by Eberhard Zwicker in 1961. It is named after Heinrich Barkhausen who proposed the first subjective measurements of loudness

13. Critical Bands (BARK): Comparing the bandwidth of Barks and 1/3 octave bands Barks 1/3 octave bands

14. Outdoors propagation

15. The DAlambert equation The equation comes from the combination of the continuty equation for fluid motion and of the 1 st Newton equation (f=m·a). In practive we get the Eulers equation: now we define the potential of the acoustic field, which is the common basis of sound pressure p and particle velocity v: Once the equation is solved and is known, one can compute p and v. Subsituting it in Eulers equation we get:: DAlambert equation

16. Free field propagation: the spherical wave Lets consider the sound field being radiated by a pulsating sphere of radius R: v(R) = v max e i e i = cos( ) + i sin( ) Solving DAlambert equation for r > R, we get: Finally, thanks to Eulers formula, we get back pressure: k = /c wave number

17. Free field: proximity effect From previous formulas, we see that in the far field (r>> ) we have: But this is not true anymore coming close to the source. When r approaches 0 (or r is smaller than ), p and v tend to: This means that close to the source the particle velocity becomes much larger than the sound pressure.

18. Free field: proximity effect The more a microphone is directive (cardioid, hypercardioid) the more it will be sensitive to the partcile velocty (whilst an omnidirectional microphone only senses the sound pressure). So, at low frequency, where it is easy to place the microphone close to the source (with reference to ), the signal will be boosted. The singer eating the microphone is not just posing for the video, he is boosting the low end of the spectrum...

19. Free field: Impedance If we compute the impedance of the spherical field (z=p/v) we get: When r is large, this becomes the same impedance as the plane wave ( ·c). Instead, close to the source (r < ), the impedance modulus tends to zero, and pressure and velocity go to quadrature (90° phase shift). Of consequence, it becomes difficult for a sphere smaller than the wavelength to radiate a significant amount of energy.

20. Free Field: Impedance

21. Free field: energetic analysis, geometrical divergence The area over which the power is dispersed increases with the square of the distance.

22. Free field: sound intensity If the source radiates a known power W, we get: Hence, going to dB scale:

23. Free field: propagation law A spherical wave is propagating in free field conditions if there are no obstacles or surfacecs causing reflections. Free field conditions can be obtained in a lab, inside an anechoic chamber. For a point source at the distance r, the free field law is: L p = L I = L W - 20 log r - 11 + 10 log Q (dB) where L W the power level of the source and Q is the directivity factor. When the distance r is doubled, the value of Lp decreases by 6 dB.

24. Free field: directivity (1) Many soudn sources radiate with different intensity on different directions. Hence we define a direction-dependent directivity factor Q as: Q = I / I 0 where I è is sound intensity in direction, and I 0 is the average sound intensity consedering to average over the whole sphere. From Q we can derive the direcivity index DI, given by: DI = 10 log Q (dB) Q usually depends on frequency, and often increases dramatically with it. I I

25. Free Field: directivity (2) Q = 1 Omnidirectional point source Q = 2 Point source over a reflecting plane Q = 4 Point source in a corner Q = 8 Point source in a vertex

26. Outdoor propagation – cylindrical field

27. Line Sources Many noise sources found outdoors can be considered line sources: roads, railways, airtracks, etc. Geometry for propagation from a line source to a receiver - in this case the total power is dispersed over a cylindrical surface: In which Lw is the sound power level per meter of line source

28. Coherent cylindrical field The power is dispersed over an infinitely long cylinder: r L In which Lw is the sound power level per meter of line source

29. discrete (and incoherent) linear source Another common case is when a number of point sources are located along a line, each emitting sound mutually incoherent with the others: Geomtery of propagation for a discrete line source and a receiver - We could compute the SPL at teh received as the energetical (incoherent) summation of many sphericla wavefronts. But at the end the result shows that SPL decays with the same cylndrical law as with a coherent source: The SPL reduces by 3 dB for each doubling of distance d. Note that the incoherent SPL is 2 dB louder than the coherent one!

30. Example of a discrete line source: cars on the road Distance a between two vehicles is proportional to their speed: In which V is speed in km/h and N is the number of vehicles passing in 1 h The sound power level L Wp of a single vehicle is: - Constant up to 50 km/h - Increases linearly between 50 km/h and 100 km/h (3dB/doubling) - Above 100 km/h increases with the square of V (6dB/doubling) Hence there is an optimal speed, which causes the minimum value of SPL, which lies around 70 km/h Modern vehicles have this optimal speed at even larger speeds, for example it is 85 km/h for the Toyota Prius

31. Outdoors propagation – excess attenuation

32. Free field: excess attenuation Other factors causing additional attenuation during outdoors progation are: air absorption absorption due to presence of vegetation, foliage, etc. metereological conditions (temperature gradients, wind speed gradients, rain, snow, fog, etc.) obstacles (hills, buildings, noise barriers, etc.) All these effects are combined into an additional term L, in dB, which is appended to the free field formula: L I = L p = L W - 20 log r - 11 + 10 log Q - L (dB) Most of these effects are relevant only at large distance form the source. The exception is shielding (screen effect), which instead is maximum when the receiver is very close to the screen

33. Excess attenuation: temperature gradient Figure 1: normal situation, causing shadowing Shadow zone

34. Excess attenuation: wind speed gradient Vectorial composition of wind speed and sound speed Effect: curvature of sound rays

35. Excess attenuation: air absorption Air absorption coefficients in dB/km (from ISO 9613-1 standard) for different combinations of frequency, temperature and humidity: Frequency (octave bands) T (°C)RH (%)631252505001000200040008000 10700,120,411,041,933,669,6632,8117,0 15200,270,651,222,708,1728,288,8202,0 15500,140,481,222,244,1610,836,2129,0 15800,090,341,072,404,158,3123,782,8 20700,090,341,132,804,989,0222,976,6 30700,070,260,963,147,4112,723,159,3

36. Excess attenuation – barriers

37. Noise screens (1) A noise screen causes an insertion loss L: L = (L 0 ) - (L b ) (dB) where L b and L 0 are the values of the SPL with and without the screen. In the most general case, there arey many paths for the sound to reach the receiver whne the barrier is installed: - diffraction at upper and side edges of the screen (B,C,D), - passing through the screen (SA), - reflection over other surfaces present in proximity (building, etc. - SEA).

38. Noise screens (2): the MAEKAWA formulas If we only consider the enrgy diffracted by the upper edge of an infinitely long barrier we can estimate the insertion loss as: L = 10 log (3+20 N) for N>0 (point source) L = 10 log (2+5.5 N) for N>0 (linear source) where N is Fresnel number defined by: N = 2 / = 2 (SB + BA -SA)/ in which is the wavelength and is the path difference among the diffracted and the direct sound.

39. Maekawa chart

40. Noise screens (3): finite length If the barrier is not infinte, we need also to soncider its lateral edges, each withir Fresnel numbers (N 1, N 2 ), and we have: L = L d - 10 log (1 + N/N 1 + N/N 2 ) (dB) Valid for values of N, N 1, N 2 > 1. The lateral diffraction is only sensible when the side edge is closer to the source-receiver path than 5 times the effective height. S R h eff

41. Noise screens (4) Analysis: The insertion loss value depends strongly from frequency: low frequency small sound attenuation. The spectrum of the sound source must be known for assessing the insertion loss value at each frequency, and then recombining the values at all the frequencies for recomputing the A-weighted SPL. SPL (dB) f (Hz) No barrier – L 0 = 78 dB(A) Barrier – L b = 57 dB(A)