1. Bench Tools + (Metalwork)

2. The 300mm rule is marked out in both Metric and Imperial sizes Rule The Rule is made from Stainless Steel Metric Scale (mm) Imperial Scale (Inches)

3. Odd Leg Callipers are used to draw a line parallel to an edge Odd Leg Callipers

4. A Scriber is used to mark out on metal Scriber

5. An Engineers square was used to mark lines at right angles to an edge. Engineers square

6. Each work station is equipped 4 files 1 Rough cut Rectangular File 1 Smooth cut Rectangular file 1 Half Round File 1 Round File One edge of the file has no teeth. This is called the Safe Edge Remember never use a file with a broken or missing handle. Files The part of the file inside the handle is called the Tang

7. The Centre punch and Ball Pein Hammer are used to mark the centres of holes before drilling Centre Punch is made from high carbon steel Ball Pein Hammer Centre Punch

8. Spring Dividers Spring dividers are used to mark curves on metal. To obtain the best results you should always Centre punch the middle of your curve before you try to use the dividers

9. The End