3. EET 107 Principles of Electronics Doug Jenkins Winter 2013 Provides an overview of aerospace manufacturing, avionics and instrumentation.

4. Employer Identified Job Skills

5. A and P / Airframe and Power plant

6. FAA Definitions Aircraft means a device that is used or intended to be used for flight in the air. Airframe means the fuselage, booms, nacelles, cowlings, fairings, airfoil surfaces (including rotors but excluding propellers and rotating airfoils of engines), and landing gear of an aircraft and their accessories and controls. Airplane means an engine-driven fixed-wing aircraft heavier than air, that is supported in flight by the dynamic reaction of the air against its wings.

7. FAA Definitions Appliance means any instrument, mechanism, equipment, part, apparatus, appurtenance, or accessory, including communications equipment, that is used or intended to be used in operating or controlling an aircraft in flight, is installed in or attached to the aircraft, and is not part of an airframe, engine, or propeller.

8. DOT Department of Transportation FAA Federal Aviation Administration

9. Law Criminal Law Civil Law Administrative Law

10. Criminal Law Public Grievance Felonies, Misdemeanors, Infractions Proof: Beyond a Reasonable Doubt

11. Civil Law Private Disputes Contract, Property, Corporate Proof: Preponderance of Evidence

12. Administrative Law Administrative Law is an area of law derived from the rules, regulations and procedures of governmental administrative agencies. The regulations of these agencies sometimes have the force and effect of law, and decisions are often rendered by these agencies in a way parallel to that of the courts. Aviation and the Law 2 nd Edition Laurence Gesell Pg 67

13. CFRs Code of Federal Regulations Title 14 Aeronautics and Space Chapter I FAA, DOT Subchapter A, B, C… Part 1,2,3… Subpart A, B, C Part is the term used in the industry.

14. Part 1 DEFINITIONS AND ABBREVIATIONS Part 21CERTIFICATION PROCEDURES FOR PRODUCTS AND PARTS Part 23 AIRWORTHINESS STANDARDS: NORMAL, UTILITY, ACROBATIC, AND COMMUTER CATEGORY AIRPLANES Part 25AIRWORTHINESS STANDARDS: TRANSPORT CATEGORY AIRPLANES Part 39AIRWORTHINESS DIRECTIVES Part 43 MAINTENANCE, PREVENTIVE MAINTENANCE, REBUILDING, AND ALTERATION

15. 21.1 Applicability 23.1Applicability 25.1 Applicability 39.1Applicability 43.1Applicability Part ##.1 Applicability

16. (STC) Supplemental Type Certificate (TSO) Technical Standard Order (TCDS) Type Certificate Data Sheet (PMA) Parts Manufacturer Approval

17. (AD) Airworthiness Directives ADs compliance is mandatory. (AC) Advisory Circulars ACs are to inform, explain and provide guidance.

18. PART 91—GENERAL OPERATING AND FLIGHT RULES Subpart C—Equipment, Instrument, and Certificate Requirements 91.205 Instrument and equipment requirements. 91.207 Emergency locator transmitters. 91.215 ATC transponder and altitude reporting equipment. 91.219 Altitude alerting systems. 91.221 Traffic alert and collision avoidance system equipment. 91.223 Terrain awareness and warning system. 91.225 Automatic Dependent Surveillance-Broadcast.

19. For VFR flight during the day, the following instruments are required: (1) Airspeed indicator. (2) Altimeter. (3) Magnetic direction indicator. (4) Tachometer for each engine. (5) Oil pressure gauge for each engine. (6) Temperature gauge for each liquid-cooled engine. (7) Oil temperature gauge for each air-cooled engine. (8) Manifold pressure gauge for each altitude engine. (9) Fuel gauge for each tank. (10) Landing gear position indicator, if the aircraft has a retractable landing gear. Avionics Training pg 156

20. For IFR flight, the following instruments and equipment are required: ( 1) Instruments and equipment specified in paragraph (b) and, paragraph (c) of this section. (2) Two-way radio communication and navigation equipment suitable for the route to be flown. (3) Gyroscopic rate-of-turn indicator. (4) Slip-skid indicator. (5) Sensitive altimeter adjustable for barometric pressure. (6) A clock with a sweep-second pointer or digital presentation. (7) Generator or alternator of adequate capacity. (8) Gyroscopic pitch and bank indicator (artificial horizon). (9) Gyroscopic direction indicator. (10) Flight at and above 24,000 feet MSL (FL 240) approved DME or a suitable RNAV system. Avionics Training pg 156

21. 91.411 Altimeter system tests and inspections. (a) No person may operate an airplane, or helicopter unless: (1) Within the preceding 24 calendar months, each static pressure system, each altimeter instrument, and each automatic pressure altitude reporting system has been tested and inspected. 91.413 ATC transponder tests and inspections. (a) No persons may use an ATC transponder that is specified in this chapter unless, within the preceding 24 calendar months, the ATC transponder has been tested and inspected. (c) The tests and inspections specified in this section must be conducted by a certificated repair station properly equipped to perform those functions.

22. NTSB National Transportation Safety Board

23. NTSB Notification: Property damage more than $25,000 Fire, in flight Accident Collision, in flight Turbine failure Illness of crew member Overdue aircraft No control: control failure of any sort NTSB National Transportation Safety Board

24. The Federal Communications Commission regulates interstate and international communications by radio, television, wire, satellite and cable in all 50 states, the District of Columbia and U.S. territories. It was established by the Communications Act of 1934.

25. General Radiotelephone Operator License Is required to adjust, maintain, or internally repair FCC licensed radiotelephone transmitters in the aviation, maritime, and international fixed public radio services.

26. IATA International Air Transport Association ICAO International Civil Aviation Organization Page 5

27. Foreign Authorities

28. Safety and Security

32. Occupational Safety and Health Administration 32

33. OSHA’s Mission The mission of OSHA is to save lives, prevent injuries and protect the health of America’s workers. Some of the things OSHA does to carry out its mission are: – developing job safety and health standards and enforcing them. – maintaining a reporting and recordkeeping system to keep track of job-related injuries and illnesses. – providing training programs. 33

34. OSHA’s Recordkeeping rule requires most employers with more than 10 workers to keep a log of injuries and illnesses. 34 Your Right to…  Workers have the right to review the current log, as well as the logs stored for the past 5 years.  Workers also have the right to view the annually posted summary of the injuries and illnesses (OSHA 300A).

35. Employers are Required to: 35 REPORTING AND RECORDING CHECKLIST Employers must: Report each worker death Report each incident that hospitalizes 3 or more workers Maintain injury & illness records Inform workers how to report an injury or illness to the employer Make records available to workers Allow OSHA access to records Post annual summary of injuries & illnesses

36. Employers must have a written, complete hazard communication program that includes information on: 36 Your Right to…  Container labeling,  Material Safety Data Sheets (MSDSs), and  Worker training., and personal protective equipment.

37. Personal Protection

38. Restriction of Hazardous Substances (RoHS) Waste Electrical and Electronic Equipment (WEEE)

39. ESD Electro Static Discharge

40. ESD

42. ESD Packing Material

43. Foreign Object Debris Foreign Object Damage FOD

44. Assignment # 1

45. FAA.GOV