1. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |1 BPL Introduction CNP is installing a Broadband over Power Line (BPL) communications infrastructure to facilitate distribution system automation. The BPL equipment injects/receives a high frequency (3-30 Mhz) data signal into/from one phase of an existing distribution ckt. There is an injector unit at or near the substation that is connected to a high speed data communication path fiber/ethernet). Then there are repeaters installed along the circuit to amplify and re- broadcast the signal. The BPL equipment will be connected to utility devices to provide a communication path.

2. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |2 BPL Introduction For 2006, 41 12kV ckts are scheduled to have BPL equipment installed. IBM has been hired as the BPL system integrator, and they will be doing the BPL design. The design consists of determining how many devices will be required per ckt and approximately where the devices should be located.

3. Distribution Automation Project © Copyright IBM Corporation 2006 BPL Network Design Bellaire BI01 Circuit March 12th, 2006 V1.9

4. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |4 Table of Contents  Overall circuit map  GIS map of individual installation point  Injection Point + Sensor (comfort stn) design  BPL + CCU design  RF design  Logical network design  Network address design

5. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |5 The BI01 circuit will have two BPL nodes at the pole locations shown below. Node #1 TP-Bi01 Node #2 NodeTypeNotes Node #1 BPL Injection + comfort stn HE point Node #2BPL + CCU

6. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |6 Node #1 is the BPL injection point + sensor station for BI01, it is the first pole past the Terminal Pole of BI01.

7. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |7 Node #2 is a BPL + CCU installation point

8. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |8 The injector node (Node #1) will be connected with multimode fiber to the backhaul network at the Bellaire substation control-house. CNP Backhaul Network BPL/AMM Servers Checkpoint Firewall IBM Server Rack Cisco 6509 Switch Cisco 2960 Switch Fujitsu FW4100 Centerpoint ECDC Fujitsu FW4020-1 Cisco 3750 Switch Bellaire Substation Controlhouse Fiber Dist. Panel BPL MV Coupler BPL MV Gateway LV 120V 12 KV MV Tap Cat5e Fiber – MM 50/125 RG-58 Ground AC 120V MV 12KV C-Phase Comfort Station

9. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |9 Cat5e Fiber –MM 50/125 RG-58 Ground AC 120V 12 KV MV Tap BPL Repeater Node With RF Meter Collector BPL MV Coupler BPL MV Gateway CCU RF Diplexer* The second node (Node #2) will also a have an AMR Collector Unit (CCU). C - Phase Node #2

10. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |10 RF Band allocation for BI01 Frequency Mode: 1 for Node #1 and Node #2 Frequency range 3MHz – 13 MHz Frequency notching will be used to notch out the amateur radio bands Node #1Node #2 MV Coupler Mode 1 Filter “next” port “Previous” port 12 KV line, C-Phase

11. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |11 BI01 network logical diagram

12. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |12 This table shows the BPL IP addressing for BI01. Site TypeNetwork AddrAddress RangeSubnet MaskAssigned To Bellaire10.144.0.010.144.0.1 - 10.144.31.254255.255.240.0 -or- /19Bellaire Substation Bellaire Circuits Address RangeMaskAssigned to Bi0110.144.0.X /2410.144.0.1 - 10.144.0.254255.255.255.0VLAN Bi01 AMM CollectorsMeter collectors10.144.0.10 - 10.144.0.29255.255.255.0 Sensors 10.144.0.30 - 10.144.0.59255.255.255.0 BPL GatewaysBPL devices10.144.0.60 - 10.144.0.99255.255.255.0 Reserved 10.144.0.100 - 10.144.0.254255.255.255.0

13. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |13

14. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |14

15. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |15

16. Distribution Automation Project – BPL Network Design © Copyright IBM Corporation 2006 | January 17, 2006 |16 BPL Pictures