Download presentation
1
MIXING STUDIES General Approach of Haemostasis
Khoa Xet Nghiem Huyet Hoc
2
Mixing studies: Mixing studies are tests performed on blood plasma used to distinguish factor deficiencies from factor inhibitors Ex: lupus anticoagulant, or specific factor inhibitors, such as antibodies directed against factor VIII. coagulation screening tests are relatively insensitive to protein concentration
3
Mixing studies: Mixing studies take advantage of the fact that factor levels that are 50 percent of normal should give a normal Prothrombin time (PT) or Partial Thromboplastins time Mixing studies can help determine the appropriate next steps to take to diagnose the cause of an abnormal APTT or PT coagulation screening tests are relatively insensitive to protein concentration
4
Test method The patient plasma is mixed 1:1 with Normal pooled plasma
That contains 100% of the normal factor level results in a level ≥ 50% in the mixture (say the patient has an activity of 0%; the average of 100% + 0% = 50%). Therefore, correction with mixing indicates factor deficiency; failure to correct indicates an inhibitor.
6
Test method Some inhibitors are time dependent.
The clotting test performed immediately after the specimens are mixed may show correction because the antibody has not had time to inactivate the added factor (false positive). A test performed after the mixture is incubated for 2 hours at 37°C will show prolongation.
7
Test method Many specific factor inhibitors are time dependent, and the inhibitor will not be detected unless the test is repeated after incubation (factor VIII inhibitors are notorious for this). Nonspecific inhibitors like the lupus anticoagulant usually are not time dependent; the immediate mixture will show prolongation.
8
Reagents and Equipment
Pooled Plasma - platelet-poor plasma from 20 or more healthy, male and female adult donors. DO NOT use a single-sourced normal plasma. Pooled plasma must be used to ensure approximately 100% of all factors are present. Do Not Use Lyophilized Normal Control. Other reagents required to perform the screen test(s) (i.e., PT or PTT).
9
Reagents and Equipment
Quality Control The pooled plasma must be evaluated for the test to be performed and results must fall within the reference range or testing is repeated with a fresh aliquot of the pooled plasma.
11
Values Expected
13
Interpretation The first step when evaluating unexpected prolonged PT or PTT results is to rule out preanalytical interference, e.g., presence of contaminating heparin. If the APTT or PT is corrected by normal plasma, a factor deficiency is indicated. If the APTT or PT is not corrected by the addition of nor-mal plasma immediately, a strong inhibitor is indicated. A weak or time-dependent inhibitor is indicated by a prolonged APTT or PT following incubation at 37°C for 1 to 2 hours ( factor VIII inhibitor).
14
Table A Differentiation of Factor Deficiency and Inhibitors By Mixing Studies
1:1 Mixing Study Results Not incubated Incubated Factor deficiency Correction Immediate acting inhibitor No correction Time/temperature dependent inhibitor Correction (Falsely) Table adapted from McKenzie, S.,, Clinical l Laboratory Hematology, 2004, p. 790.
15
Possible Interpretations
Coagulation Screen Results: PT prolonged PT mixing study results: PT corrects Most likely interpretation: Factor VII deficiency Probable cause(s): Early response to warfarin, early vitamin K deficiency Rare cause: Congenital factor VII deficit PTT prolonged PTT mixing study results: PTT corrects Factor deficit Factor VIII or IX (male) deficiency, or von Willebrand Disease (female) Possible cause Factor inhibitor PTT markedly prolonged (>200 seconds) Severe Contact Factor deficit Factor Prekallikrein, HMWK, XI, or XII PT and PTT prolonged PT & PTT mixing study results: PT and PTT correct Acquired, multiple factor deficiency DIC, Liver Disease, Vitamin K deficiency Possible cause: Warfarin therapy PTT slightly – moderately prolonged No correction Immediately reacting antibody inhibitor Lupus anticoagulant
16
Comment The antibody that inhibits factor VIII is most often a specific IgG antibody (temperature and time dependent) , which will cause only a slightly prolonged APTT on initial testing. If a factor VIII inhibitor is present, it is important to determine the initial level of factor activity because the development of an inhibitor complicates the management of a patient with hemophilia A when therapy involves AHF* concentrates. These should be monitored periodically. Repeating the mixing study with 4 parts patient sample and 1 part normal pooled plasma may increase the chance of detecting a weak inhibitor. *Antihemophilic factor (AHF ) : A commercially prepared source of factor VIII.
17
Notes: Be careful when thawing the pooled plasma because prolonged incubation at 37°C will selectively decrease Factor V, prolonging the results and making interpretation of the 1:1 mix test results difficult. The pooled normal plasma is stable for ~2 hours at room temperature. Initial test results for the pooled normal plasma must be within the reference range or the mix should be repeated with a fresh aliquot of pooled normal plasma.
18
Thank you http://site.iugaza.edu.ps/ialaswad/
Next Lecture: Coagulation-instruments
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.