1. Other Electrochemical Methods1 1 1 1

2. Electrogravimetric Analysis
If you wanted to test for copper ions in solution (or some other ion), you could make an electrolysis cell.
You would then run a current through the electrolytic cell containing the copper ions.
This would force the copper ions to “plate” onto the cathode electrode.
The change in mass of the cathode will tell you the original amount of copper ions in solution.

3. Electrogravimetric Analysis
You do have to have a method to determine whether the reaction is complete.
Sln color change
Fresh cathode has no more copper deposited.
Small aliquot of the sln tests negative for copper.

4. Coulometric Analysis
In coulometry, a current is run through a solution until a redox rxn is complete.
This is measured with an indicator.
The time it took to complete the reaction is then used to calculate the moles of electrons consumed.
This is then used to calculate the mass of the original analyte.
Problem: If a current of 56.0 mA for 705 s was required to reach the endpoint for the titration of mL of a monoprotic acid, what was the molarity of the HA?

5. Amperometry
In amperometry, the current between 2 electrodes driving an electrolysis reaction is measured.
The voltage is fixed.
The measured current is proportional to the amount of analyte.
Amperometry is used in oxygen monitors, glucose monitors, and other sugars.
A calibration curve of known standards is used to calculate the amount of an analyte.

6. Voltammetry
Now the current between 2 electrodes is measured while the voltage is changed.
The method of standard addition is used so that a series of graphs is obtained.
The concentration of the analyte is proportional to the peak current obtained from the graph.
This was often used to measure Vitamin C.

8. Polarography This is a type of voltammetry.
One of the electrodes is a dropping-mercury electrode.
It has the advantage that mercury is less likely to reduce H+ to hydrogen gas.
Otherwise, the process is similar.