Download presentation
Presentation is loading. Please wait.
Published byJoseph Cooper Modified over 9 years ago
1
Jeff Branson Education Outreach Coordinator Email: jeff.branson@sparkfun.com Derek Runberg Curriculum Curator Email: derek.runberg@sparkfun.com Getting Started with the Galileo
2
Go Ahead and open your box!
4
7-14V Power supply Micro SD Card Slot Micro USB Port (Client) USB Port (Host)
5
7-14V Power supply Micro SD Card Slot Micro USB Port (Client) USB Port (Host) Digital I/O Pins Analog Input Pins Power Bus (5V, GND)
6
Adding the Wifi Card Screw Driver Wifi Card Wifi Card Bracket
7
Give it Legs Screw Driver 4-40 Screws (4) 4 Plastic ¾” Stand-offs
8
Download CAT image Click here Or Download and unzip the folder from GitHub https://github.com/IntelOpenDesi gn/ConnectAnyThing/releases/tag/ v0.2.3
9
Download connect anything Open your micro SD card and use the USB adaptor. Plug it into your laptop and it will show up as a drive.
10
Copy content of CAT folder Copy all the files in the folder, but not the folder itself!
11
Paste into your MicroSD Card Copy all the files in the folder, but not the folder itself!
12
Remove Micro SD card from your computer Remove the USB key and then remove the SD card from the USB key…keep the USB key handy!
13
Slide Micro SD into your Galileo
14
Attach an Antenna
15
Power your Galileo! Use your 12V power supply Wait until the LED on pin 13 blinks and turns off –Have patience, this takes a few minutes.
16
Open up available Wi-fi networks on a device Use your phone, tablet, or laptop Look for a wi-fi network called “ConnectAnyThing” and connect Note: If you are using an apple product you may have to do this step twice!
17
Open a Browser Once connected open a browser and go to cat.com
18
The CAT Interface Active Sensor Settings Active Actuators Add a Sensor Add an Actuator Configure/ Controller Mode
19
Change Network ID! Click on the Gear and choose Change Network name. Change it to your first name for now and save. Power cycle the Galileo (turn it off and on again)
20
Look for your name Now when re-powered your name should show up as a network. Connect to it!
21
Add a Sensor Click on the yellow (+) to add a sensor Select which pin you would like use!
22
Inputs and sensors Potentiometer: Rotation as a value Center pin to input, outside pins to 5V and one to Ground…Doesn’t matter which one goes where.
23
Add a Sensor
24
Inputs and sensors / Name Pin Number Reading
25
Add an Output
26
Outputs and actuators
27
LED (Light Emitting Diode) is a light you can turn on and off! Long leg to output pin, short to Ground
28
Outputs and actuators Digital Pin Number Reading level Name Servo Selection
29
Connecting an Input to an Output Click HereThen Here
30
On for # of Seconds Fully digital pins only (13,12,8,7,4,2)
31
Scaling an input Maximum Minimum Threshold
32
Invert an Input Select to Invert value
33
Splitting an input
34
Servo Control Select Servo Control Output as 0-180 degrees
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.