1. TFT Blitzfire

2. The Task Force Blitzfire is a personal portable monitor (PPM) capable of flows of 500+ GPM and is easily deployed by one firefighter.

3. It is supplied by a single 2 ½” hose, can be pre-connected to the apparatus, and can be mounted on the exterior of the rig for rapid deployment.

4. The design of the inlet and the discharge neck creates a downward pressure that adds stability to the Blitzfire.

5. It has a rear pivoting inlet that allows the hose to stay flat to the ground.

6. The folding legs extend outward to provide lateral stability.

7. The discharge can be adjusted for a low attack angle.

8. It can be secured to the ground or another object by using the provided strap and base ring.

9. The operating handle has a ratchet feature that allows for partial opening of the monitor.
Pull the handle lock outward and pull the handle towards you.

10. It has a safety feature that shuts off the monitor when a sudden force (in excess of) 1G is introduced.
Hydraulic dampening in the handle prevents water hammer in the Blitzfire.

11. Not for extending lines
Because of the automatic shut-off feature, you should NOT extend hose lines from the Blitzfire.
Any force greater than 1 G will automatically shut the Blitzfire down:
Laterally
From the top
Blunt force
Water hammer (from the pump side)
Any of these will trip this feature.

12. Discharge pressures with solid tip
100 feet of 2 ½”
100 PSI = 400 GPM
125 PSI = 450 GPM
150 PSI = 500 GPM

13. Solid tip (continued) 200 feet of 2 ½” 150 PSI = 435 GPM

14. Discharge pressures with fog tip
100 Feet of 2 ½”
Standard tip setting
205 PSI = 500 GPM