1. Air / Sound Lock Iso-Booth Mix Tape EFX Step Up ~18” Raised floor in CR Glass GLASSGLASS Bulkhead Plate with inputs to board below glass EFX rack also had three Crown D-75 amps, one for CR; one for main; one for isolation. Speakers JBL Century L-100 in main; Yamaha NS-10 in CR & Iso-Booth Monitoring Avion-16 24’X24’ Stand alone garage w/o car 16’ door Glass Door Drum Riser A 110vac breaker panel was in the air-lock. All 110vac outlets on wall between control room and the main room. Each duplex outlet had its own 15A breaker. All wiring was accessible VIA panels in wall. There was quad outlets each on its own breaker, behind the EFX (and amps) rack in the wall to eliminate power strips and extension cords

2. Heat A/C Iso-Booth 24’X24’ Stand alone garage w/o car 16’ door The walls were 10’ tall. The control room ceiling was about 6’6” above floor. The entire HVAC unit sat upon rafters above top of the control room on an isolated floor. All return air and supply grills entered and exited in about a 1’ space although the attic space was much higher

3. Glass to control room Door is to Iso booth Door is to air lock Looking at CR from studio

4. Ext finish Int finish Batt insulation laid in. It does get crunched up on one side but no big deal Walls 8”2”X6”