1. Our Ultimate Measure of Success Sending each miner home safe and healthy Every Day ……Every Shift

2. MSHA Part 100 Overview

3. MSHA Part 100 Reformulates the process of assigning points to arrive at an assessment. Adds a provision to an operator’s history addressing “repeat violations”. Eliminates the $60 single penalty assessment for “non-S&S violations”. Increases the dollar amount of each point in a conversion table. Maximum $60,000 for civil penalty (no change) Minimum of $2000 and $4000 for Unwarrantable failure and Withdrawal orders respectively. Failure to notify MSHA within 15 minutes of a fatality or injury that has reasonable potential to be a fatality from $5,000 to $60,000. Makes all violations subject to “special assessment.”

5. MSHA Part 100 What is an Accident 1.A death of an individual at a mine; 2.An injury to an individual at a mine, which has reasonable potential to cause death; 3.An entrapment of an individual for more than 30 minutes; 3. An entrapment of an individual for more than 30 minutes or which has a reasonable potential to cause death; 4.An unplanned inundation of a mine by a liquid or gas; 5.An unplanned ignition or explosion of gas or dust; 6.An unplanned mine fire not extinguished within 30 minutes of discovery; 6.In underground mines, an unplanned mine fire not extinguished within 10 minutes of discovery; in surface mines and surface areas of underground mines, an unplanned fire not extinguished within 30 minutes of discovery; 7.An unplanned ignition or explosion of a blasting agent or an explosive; 8.An unplanned roof fall at or above the anchorage zone in active workings where roof bolts are in use; or, an unplanned roof or rib fall in active workings that impairs ventilation or impedes passage 9.A coal or rock outburst that causes withdrawal of miners or which disrupts regular mining activity for more than one hour; 10.An unstable condition at an impoundment, refuse pile or culm bank which requires emergency action in order to prevent failure, or which causes individuals to evacuate an area; or, failure of an impoundment, refuse pile or culm bank; 11.Damage to hoisting equipment in shaft or slope which endangers an individual or which interferes with use of the equipment for more than 30 minutes; and 12.An event at a mine that causes death or bodily injury to an individual not at the mine at the time of the event.

6. MSHA Part 100 MSHA new “Miner Act” Part 100 provisions and assessments –Graduated assessment scale for citations based on: Size of operation (hours worked) Size of controlling entity (hours worked) Degree of Negligence Gravity (severity, likelihood of event, # persons potentially affected) Citation History History of repeat violations

7. MSHA Part 100 Size of Operation Annual Hours Worked Penalty Pts. Size of Individual Mine O to 5,000 0 Over 5,000 to 10,000 1 Over 50,000 to 100,000 5 Over 100,000 to 200,000 6 Over 200,000 to 300,000 7 Over 300,000 to 500,000 8 Over 500,000 to 700,000 9 Size of Controlling Entity Over 3,000,000 to 5,000,000 8

8. MSHA Part 100 DEGREE OF NEGLIGENCE PENALTY POINTS Points –No negligence 0 –Low Negligence 10 –Moderate Negligence 20 –High Negligence 35 –Reckless Disregard 50 Increase from 25 to 50 maximum penalty points

9. MSHA Part 100 GRAVITY PENALTY POINTS Likelihood of OccurrencePoints –No Likelihood 0 –Unlikely 10 –Reasonably Likely 30 –Highly Likely 40 –Occurred 50 SeverityPoints –No Lost work Days 0 –Lost or Restricted 5 –Permanently Disabling 10 –Fatal 20 Number of Persons AffectedPoints –0 0 –1 1 –5 5 –10 or more 18

10. MSHA Part 100 VIOLATION HISTORY PENALTY POINTS Violation Per Inspection Day VPID = # assessed violations (15 mos.) Divided by Total inspection days (15 Mos.) –Penalty not used for mines with less than 10 citations for the 15 month period. –Only assessed violations that have been paid or finally adjudicated –Inspection day = full or partial day at mine site per inspector. –Have the authority to take past violations into consideration, (prior to promulgation) but will pay close attention to retroactive circumstances that result in unfair penalty increases. –Using 2005 data average penalty points for M/NM was 7.6 points. –Maximum of 25 penalty points versus 20 points old rule.

11. MSHA Part 100 REPEAT VIOLATION PENALTY POINTS (New) RPID = Repeat Violations Per Inspection Day –Violation of the same standard –Penalty not used for mines with less than 6 repeat citations for the 15 month period. –Only assessed violations that have been paid or finally adjudicated –Inspection day = full or partial day at mine site. –Still no commitment retroactivity –Using 2005 data 698 of 10,227 mines had at least 6 violations or more –Maximum of 20 penalty points

12. MSHA Part 100 Flagrant Violations may be assessed a maximum civil penalty of $220,000. Flagrant Definition…. “a reckless or repeated failure to make reasonable efforts to eliminate a known violation of a mandatory health or safety standard that substantially and proximately caused, or reasonably could have been expected to cause, death or serious bodily injury.”

13. PART 100 Examples Elevated Platform Housekeeping Issue

14. MSHA Part 100 Example #1: Non S&S Equivalent Old Rule: $60 single penalty assessment New Rule: Size of operation (hours worked) 7 Size of controlling entity (hours worked) 8 Degree of Negligence (Low) 10 Gravity: Unlikely, LTA, 2 persons affected10-5-2 Citation History 12 History of repeat violations 0 Total Points 54 points or $112* or $100 w/GFR *MSHA projects, under the final rule that 59% of all violations will receive the minimum penalty of $112 or $100 with good faith reduction. This compares with 72% of all citations that received the $60 single penalty assessment under the old rule.

15. MSHA Part 100 Example #2: S&S Equivalent New Rule: Size of operation (hours worked) 7 Size of controlling entity (hours worked) 8 Degree of Negligence (Moderate) 20 Gravity: Reas. likely, LTA, 2 persons affected 30-5-2 Citation History 12 History of repeat violations 0 Total Points 84 points or $764* *MSHA estimates M/NM cement facilities average penalty assessment is going to increase from $220 to $481; a 119% increase.

16. MSHA Part 100 Example #3: S&S High Negligence/Highly Likely/Fatal New Rule: Size of operation (hours worked) 7 Size of controlling entity (hours worked) 8 Degree of Negligence (High) 35 Gravity: Highly likely, Fatal, 5 persons affected 40-20-5 Citation History 12 History of repeat violations 0 Total Points 127 points or $23,825

17. MSHA Part 100 Penalty Conversion Table PointsPenalty ($) 60 or Fewer$112 70$249 80$555 90$1,235 100$2,748 110$6,115 120$13,609 130$30,288 140 or more$60,000

18. MSHA Part 100 NEXT STEPS: –Thoroughly review all citations under New Part 100 rule Know your History (track on an ongoing basis) –Management Training on proper conduct during MSHA Inspections Opening and closing conferences Accompanying Inspectors What to say - What not to say Questions to ask inspectors Importance of good communications Required records –Improved relationship building with District Offices H&S Operations (Partnership and Register as Safety Professional) –Improve Workplace Examination Program Documentation Follow up on deficiencies Accountability

19. Our Ultimate Measure of Success Sending each miner home safe and healthy Every Day ……Every Shift

20. Questions?