Presentation is loading. Please wait.

Presentation is loading. Please wait.

0 3 2 1 4 5 6 7 8 9 10 12 11 15 14 13 Basic Stamp Free Pins 2 - 7 15 These pins can be used by the operator for digital Inputs and Outputs Used Pins 0.

Published byGabriel Lindsey Modified over 9 years ago

Similar presentations

Presentation on theme: "0 3 2 1 4 5 6 7 8 9 10 12 11 15 14 13 Basic Stamp Free Pins 2 - 7 15 These pins can be used by the operator for digital Inputs and Outputs Used Pins 0."— Presentation transcript:

1 0 3 2 1 4 5 6 7 8 9 10 12 11 15 14 13 Basic Stamp Free Pins 2 - 7 15 These pins can be used by the operator for digital Inputs and Outputs Used Pins 0 1 8 - 14 These pins are dedicated to the boards communications system and should not be used for anything else Not to Scale

2 CanSat 2002 LED Serial to Computer Unused Pin GND Connect your circuits to GROUND here TxRx Connect Speaker Connect Mic Supply Ground Battery Connection SupplyGround AC Adapter Connection Short when Battery Powered Short when powered from wall Connect your circuits to POWER on the middle pin Not to Scale CanSat 2002: Board Connections

3 ADC0831 +5 7 5 6 4 2 3 18 P2 P3 P4 CS (On/Off) Clock Digital Data Out +5 RRTRT Thermister V2V2 V2 =V2 = Digital Data Out 255 * 5 volts R T =R*( 5 V2V2 - 1) P7 P6 LED 1 LED 2 2.5K Ohm ~ =R ~ =R Not to Scale Sensor Circuit Diagram: Including ADC0831 A-D Converter Analog Data In

4

Download ppt "0 3 2 1 4 5 6 7 8 9 10 12 11 15 14 13 Basic Stamp Free Pins 2 - 7 15 These pins can be used by the operator for digital Inputs and Outputs Used Pins 0."

Similar presentations

1 Cable Assembly for CanSat. 2 Heat Shrink Tubing Battery Pack Connection Pin Connectors Radio Cables Mic & Speaker Plugs See close up connection page.

1 Cable Assembly for CanSat. 2 Heat Shrink Tubing Battery Pack Connection Pin Connectors Radio Cables Mic & Speaker Plugs See close up connection page.
10 Ways to Ruin Your Mini-Max microcontroller (and lose $69)

10 Ways to Ruin Your Mini-Max microcontroller (and lose $69)
Anurag Dwivedi & Rudra Pratap Suman.  Open Source electronic prototyping platform based on flexible easy to use hardware and software.

Anurag Dwivedi & Rudra Pratap Suman.  Open Source electronic prototyping platform based on flexible easy to use hardware and software.
Data Acquisition ET 228 Chapter

Data Acquisition ET 228 Chapter
ACES PROGRAM Brad Ellison 28 January 2003 Basics of Interfacing to CanSat.

ACES PROGRAM Brad Ellison 28 January 2003 Basics of Interfacing to CanSat.
FLIGHT READINESS REVIEW TEAM HAWAII. LEO HANO FULL SCALE LOW POWER March 13, 2011 Motor = K780R.

FLIGHT READINESS REVIEW TEAM HAWAII. LEO HANO FULL SCALE LOW POWER March 13, 2011 Motor = K780R.
Power to circuit board Ground Positive Neutral We opened the back end of the fixture to expose the AC wiring.

Power to circuit board Ground Positive Neutral We opened the back end of the fixture to expose the AC wiring.
Part 1: Introduction FRC 2907. Introduction  FRC 2907 since 2008  Each area of the robot has a team assigned  The Electronics team is headed this year.

Part 1: Introduction FRC Introduction  FRC 2907 since 2008  Each area of the robot has a team assigned  The Electronics team is headed this year.
Basic Stamp II is kinda cool. - 2048 Bytes of EEPROM(non-volatile) - Clock speed of 20 MHz. - Holds 600 lines of code in EEPROM - executes an average of.

Basic Stamp II is kinda cool Bytes of EEPROM(non-volatile) - Clock speed of 20 MHz. - Holds 600 lines of code in EEPROM - executes an average of.
Analog-to-Digital Converters

Analog-to-Digital Converters
Ramrod IV Micromouse 396. The Team  Andrew Igarashi – Programming  Kevin Li – Hardware  Amy Maruyama – Hardware  Stephen Nakamura – Hardware  Quang.

Ramrod IV Micromouse 396. The Team  Andrew Igarashi – Programming  Kevin Li – Hardware  Amy Maruyama – Hardware  Stephen Nakamura – Hardware  Quang.
ESE Lab Computer based Temperature Control Sid Deliwala, ESE Labs.

ESE Lab Computer based Temperature Control Sid Deliwala, ESE Labs.
Project Check Point 3 Audio Interface Jeff Du. Overview Project specs and overview next Tue. Mid-term next Thurs. This audio interface lab is REALLY easy.

Project Check Point 3 Audio Interface Jeff Du. Overview Project specs and overview next Tue. Mid-term next Thurs. This audio interface lab is REALLY easy.
Solar Energy Labs – Part 1 ENGR 1181. Today's Learning Objectives  After today's class, students will be able to: Describe and build both a calibration.

Solar Energy Labs – Part 1 ENGR Today's Learning Objectives  After today's class, students will be able to: Describe and build both a calibration.
CR1000s are only one part of a data acquisition system. To get good data, suitable sensors and a reliable data retrieval method are required. A failure.

CR1000s are only one part of a data acquisition system. To get good data, suitable sensors and a reliable data retrieval method are required. A failure.
“Power Supply” Controls Voltage Difference in Voltage is set Output Current is “as requested” by attached device.

“Power Supply” Controls Voltage Difference in Voltage is set Output Current is “as requested” by attached device.
Embedded Programming and Robotics

Embedded Programming and Robotics
Digital I/O Connecting to the Outside World

Digital I/O Connecting to the Outside World
Image of Arduino. Arduino discussion Address issues with circuit walk-through – Electricity, Programming, Arduino Concepts Work on BeatTable (next week)

Image of Arduino. Arduino discussion Address issues with circuit walk-through – Electricity, Programming, Arduino Concepts Work on BeatTable (next week)
LSU 06/04/2007Expanding the BASIC Stamp1 Expanding the BASIC Stamp: Useful peripherals Programming Unit, Lecture 6.

LSU 06/04/2007Expanding the BASIC Stamp1 Expanding the BASIC Stamp: Useful peripherals Programming Unit, Lecture 6.

Similar presentations

Ads by Google