1. Modeling and Analysis of Computer Networks (The physical Layer) Ali Movaghar Winter 2009

2. The Theoretical Basis for Data Communication Linear Time-Invariant Filtering Fourier Analysis Bandwidth-Limited Signals Maximum Data Rate of a Channel

3. Linear Time-Invariant Filtering  If input s(t) yields output r(t), then for any τ, input s(t-τ) yields output r(t- τ).  If input s(t) yields output r(t), then for any real number α, αs(t) yields αr(t).  If input s 1 (t) yields output r 1 (t) and s 2 (t) yields output r 2 (t), then s 1 (t) + s 2 (t) yields output r 1 (t) + r 2 (t).

4. Example T T 2T S(t) r(t) T 2T 3T 4T 5T6T 0 0 T 2T 3T 4T 5T 6T 0 0

5. The convolution integral formula Let h(t) be the impulse response of the channel. Then r(t) = s(τ) h(t-τ) dτ S(t) τ τ+δτ+δ Area ≈ δs(τ) Area ≈ δs(τ+δ)

6. Frequency Response (1) Let s(t) = e j2πft where j =. Then r(t) = H(f) e j2πft where H(f) = h(τ) e -j2πfτ dτ H(f) above is called the Fourier transform of h(t).

7. Frequency Response (2) Let S(f) be the Fourier transform of s(t). That is S(f) = s(t) e -j2πft dt By inverse Fourier transform, we can write s(t) = S(f) e j2πft df It follows r(t) = H(f) S(f) e j2πft df Thus, we get R(f) = H(f) S(f) where R(f) is the Fourier transform of r(t).

8. Fourier Series Theorem: Let g(t) be a periodic function with period T. Then where f = 1/T is the fundamental frequency, a n and b n are the sine and cosine amplitudes of the nth harmonics, c is a constant. We have:

9. Example Let us consider the transmission of the ASCII character “b” encoded in an 8-bit byte. The pattern that is to be transmitted is 01100010. The Fourier analysis of this signal yields the coefficients:

10. Bandwidth-Limited Signals A binary signal and its root-mean-square Fourier amplitudes. (b) – (c) Successive approximations to the original signal.

11. Bandwidth-Limited Signals (2) (d) – (e) Successive approximations to the original signal.

12. Bandwidth-Limited Signals (3) Relation between data rate and harmonics.

13. Guided Transmission Data  Magnetic Media  Twisted Pair  Coaxial Cable  Fiber Optics

14. Magnetic Media An industry standard Ultrium tape can hold 200 gigabytes. A box 60 × 60 × 60 can hold about 1000 of these tapes, or 1600 trabits (1.6 petabits). A box of tapes can be delivered anywhere in Iran in 24 hours by “Post-e-Pishtaz”. The effective bandwidth is 166 terabits/86,400 sec, or 19 Gbps.

15. Twisted Pair (a) Category 3 UTP. (b) Category 5 UTP. Category 3 (16 MHz) Category 5 (100 MHz) Category 6 (250 MHz) Category 7 (600 MHz)

16. Coaxial Cable A coaxial cable. Coaxial cable (1GHz)

17. Fiber Optics (a) Three examples of a light ray from inside a silica fiber impinging on the air/silica boundary at different angles. (b) Light trapped by total internal reflection.

18. Transmission of Light through Fiber Attenuation of light through fiber in the infrared region. Attenuation in decibels = 10 log (transmitted power / received power)

19. Bandwidth f = 1/λ df/dλ = - c/ λ 2 Example: for λ = 1.3 × 10 -6 Δλ = 0.17 × 10 -6 We have Δf = 30 THz For 8 bits/Hz, we get 240Tbps

20. Fiber Cables (a) Side view of a single fiber. (b) End view of a sheath with three fibers.

21. Fiber Cables (2) A comparison of semiconductor diodes and LEDs as light sources. Light Sources: LEDs and semiconductor diodes Receiving ends: Photodiodes (1Gbps)

22. Fiber Optic Networks A fiber optic ring with active repeaters.

23. Fiber Optic Networks (2) A passive star connection in a fiber optics network.

24. Wireless Transmission  The Electromagnetic Spectrum  Radio Transmission  Microwave Transmission  Infrared and Millimeter Waves  Lightwave Transmission

25. The Electromagnetic Spectrum The electromagnetic spectrum and its uses for communication.

26. Radio Transmission (a) In the VLF, LF, and MF bands, radio waves follow the curvature of the earth. (b) In the HF band, they bounce off the ionosphere.

27. Politics of the Electromagnetic Spectrum The ISM bands in the United States.

28. Lightwave Transmission Convection currents can interfere with laser communication systems. A bi-directional system with two lasers is pictured here.

29. Communication Satellites  Geostationary Satellites  Medium-Earth Orbit Satellites  Low-Earth Orbit Satellites  Satellites versus Fiber

30. Communication Satellites Communication satellites and some of their properties including altitude above the earth, round-trip delay time and number of satellites needed for global coverage.

31. Communication Satellites (2) The principal satellite bands.

32. Communication Satellites (3) VSATs using a hub.

33. Low-Earth Orbit Satellites Iridium (a) The Iridium satellites from six necklaces around the earth. (b) 1628 moving cells cover the earth.

34. Globalstar (a) Relaying in space. (b) Relaying on the ground.

35. Public Switched Telephone System  Structure of the Telephone System  The Politics of Telephones  The Local Loop: Modems, ADSL and Wireless  Trunks and Multiplexing  Switching

36. Structure of the Telephone System (a) Fully-interconnected network. (b) Centralized switch. (c) Two-level hierarchy.

37. Structure of the Telephone System (2) A typical circuit route for a medium-distance call.

38. Major Components of the Telephone System  Local loops  Analog twisted pairs going to houses and businesses  Trunks  Digital fiber optics connecting the switching offices  Switching offices  Where calls are moved from one trunk to another

39. The Politics of Telephones The relationship of LATAs, LECs, and IXCs. All the circles are LEC switching offices. Each hexagon belongs to the IXC whose number is on it.

40. The Local Loop: Modems, ADSL, and Wireless The use of both analog and digital transmissions for a computer to computer call. Conversion is done by the modems and codecs.

41. Amplitude Modulation (AM) The (digital) signal s(t) (called the baseband signal) is multiplied by a sinusoidal carrier, say cos(2πf 0 t), to generate a modulated signal s(t) cos(2πf 0 t).

42. Amplitude Modulation (AM) Amplitude modulation. The frequency characteristic of the waveform s(t) is shifted up and down by f 0 in frequency.

43. Amplitude Modulation (AM) At the receiver, the modulated signal is again multiplied by cos(2πf 0 t), yielding a received signal r(t) = s(t) cos 2 (2πf 0 t) =s(t)/2 +1/2 s(t) cos(4πf 0 t). AM is rather sensitive to the receiver knowing the correct phase of the carrier. Fore example, if the modulated signal s(t) cos(2πf 0 t) were multiplied by sin(2πf 0 t), the low frequency demodulated waveform would disappear.

44. Quadrature Amplitude Modulation (QAM) This suggest, however, the possibility of transmitting twice as many bits by a technique known as quadrature amplitude modulation (QAM). Here, the incoming bits are mapped into two baseband signals, s 1 (t) and s 2 (t). Then s 1 (t) is multiplied by cos(2πf 0 t) and s 2 (t) by sin(2πf 0 t); the sum of these products forms the transmitted QAM signal. The received waveform is separately multiplied by cos(2πf 0 t) and sin(2πf 0 t). The first muliplication (after filtering out the high-frequency component) yields s 1 (t)/2, and the second yields s 2 (t)/2.

45. Modems (2) Bits to samples Pulse shape X X + sin(2πf 0 t) K bits s1s1 s2s2 cos(2πf 0 t) Modulated waveform (a) Modulator X X sin(2πf 0 t) cos(2πf 0 t) Carrier rec. Timing rec. Adaptive equilizer Samples To bits s1s1 s2s2 (b) Demodulator

46. Modems (2) (a) A binary signal (b) Amplitude modulation (c) Frequency modulation (d) Phase modulation

47. Modems (2) (a) QPSK. (b) QAM-16. (c) QAM-64.

48. Modems (3) (a) V.32 for 9600 bps. (b) V32 bis for 14,400 bps. (a) (b)

49. Digital Subscriber Lines Bandwidth versus distanced over category 3 UTP for DSL.

50. Digital Subscriber Lines (2) Operation of ADSL using discrete multitone modulation.

51. Digital Subscriber Lines (3) A typical ADSL equipment configuration.

52. Wireless Local Loops Architecture of an LMDS system.

53. Frequency Division Multiplexing (a) The original bandwidths. (b) The bandwidths raised in frequency. (b) The multiplexed channel.

54. Wavelength Division Multiplexing Wavelength division multiplexing.

55. Time Division Multiplexing The T1 carrier (1.544 Mbps).

56. Time Division Multiplexing (2) Delta modulation.

57. Time Division Multiplexing (3) Multiplexing T1 streams into higher carriers.

58. Time Division Multiplexing (4) Two back-to-back SONET frames.

59. Time Division Multiplexing (5) SONET and SDH multiplex rates.

60. The Mobile Telephone System  First-Generation Mobile Phones: Analog Voice  Second-Generation Mobile Phones: Digital Voice  Third-Generation Mobile Phones: Digital Voice and Data

61. Advanced Mobile Phone System (a) Frequencies are not reused in adjacent cells. (b) To add more users, smaller cells can be used.

62. Channel Categories The 832 channels are divided into four categories:  Control (base to mobile) to manage the system  Paging (base to mobile) to alert users to calls for them  Access (bidirectional) for call setup and channel assignment  Data (bidirectional) for voice, fax, or data

63. D-AMPS Digital Advanced Mobile Phone System (a) A D-AMPS channel with three users. (b) A D-AMPS channel with six users.

64. GSM Global System for Mobile Communications GSM uses 124 frequency channels, each of which uses an eight-slot TDM system

65. GSM (2) A portion of the GSM framing structure.

66. CDMA – Code Division Multiple Access (a) Binary chip sequences for four stations (b) Bipolar chip sequences (c) Six examples of transmissions (d) Recovery of station C’s signal

67. Third-Generation Mobile Phones: Digital Voice and Data Basic services an IMT-2000 network should provide:  High-quality voice transmission  Messaging (replace e-mail, fax, SMS, chat, etc.)  Multimedia (music, videos, films, TV, etc.)  Internet access (web surfing, w/multimedia.)

68. Cable Television  Community Antenna Television  Internet over Cable  Spectrum Allocation  Cable Modems  ADSL versus Cable

69. Community Antenna Television An early cable television system.

70. Internet over Cable Cable television

71. Internet over Cable (2) The fixed telephone system.

72. Spectrum Allocation Frequency allocation in a typical cable TV system used for Internet access

73. Cable Modems Typical details of the upstream and downstream channels in North America.