1. Sydney Mini Intro to DMX communications Matt Edwards

2. DMX – What is it? In the good old days, computer control of dimmers relied on the use of a small dc voltage that was proportional to different dimming level for a light. This voltage ran along individual wires for individual channels and the most popular voltage was 0 – 10Vdc. This system suffers from two major problems: 1.It is prone to noise and earth loops if not wired properly over long distances. 2.It can be very non linear with the different kinds of lamps in use today.

3. DMX512 The U.S.Institute of Theatre Technology first developed the DMX512 protocol in 1986 as a standard interface between dimmers and consoles.U.S.Institute of Theatre Technology The “Standard” has evolved to enable additional equipment to be added like intelligent lights, colour changers, yokes, strobes, smoke machines, lasers and even confetti dispensers.

4. DMX Ports and Universes A single DMX port transmits the magnitude value information for a maximum 512 channels (or lesser) only. This port is known as a DMX universe. No of UNIVERSE CHANNELS 1512 21024 52560

5. Physical Info The DMX data stream clocks out at the rate of 250Khz which means each bit is measured at 4 micro seconds widths. The RS485 standard uses two/three wires to transmit the digital HIs & LOs

6. Addressing Each Controller needs to have the Start Address set or programmed

7. DMX & RDM The original standard was a single directional data path from the Lighting Consol to the Dimmer. RDM (Remote Device Management) requires bidirectional communications between the console and the dimmer. In our community, there has been limited work done with RDM, but it may become more popular in the near future.

8. Renard Renard is a Serial communications protocol Character Format –Baud Rate can vary, current firmware is programmed for 57600. –1 Start Bit, 8 Data Bits, No Parity bit, 1 Stop bit (8N1) Special Characters –0x7D - Pad byte, silently discarded by controller firmware, inserted by host PC to prevent Tx overrun –0x7E - Sync byte, start of packet marker. –0x7F - Escape byte, used as prefix for encoding dimmer levels that correspond to the special characters. Packet Format –Byte 0 - 0x7E (sync byte) –Byte 1 - Command/address byte (usually 0x80, see below) –Byte 2-n - Dimmer values (0-0xFF, values 0x7D, 0x7E and 0x7F have special encoding, all others are sent raw) Both RS232 and RS485 are used

9. Renard Channel Limits Dependant on Baud rate and refresh rate DMX – 512 channels per Universe Refresh Rate Baud Rate100m s 50 ms25ms 1152001150286 57600574190143 3840038419094

10. Cable Distances The maximum distance between controllers depends on whether RS232 or RS422 is used as the physical communications method. –For RS232 the standards only specify short distances (less than 15 m), ( but past experiences in other situations suggests that it should work up to several times that distance, especially if low capacitance cable is used.) –For RS422 it should work out to a distance of more than 300m.

11. Main Differences Renard –RS232 & RS 485 –Variable Baud rate –Variable number of channels –Assumed addressing –Controllers passing remaining channels to next controller DMX –RS 485 Only –250kbit/s –512 channels per universe –Start address programmed –All controllers on a universe RX all channels

12. Renard Network

13. DMX Network

14. DMX &Renard Network

15. References Material for this presentation was taken from: –Ujjal’s DMX512 web site http://www.dmx512-online.com/whats.html –Christmas Wiki http://www.christmasinshirley.com/wiki/index.php? title=Renard