1. SHOVELS

2. SHOVELS
William S. Otis, of the firm of Carmichael, Fairbanks and Otis, when living in Canton, Massachusetts in 1834 and 1835, while his firm was performing grading work for the Boston & Providence Railroad built the first steam excavator – a steam shovel.

3. OTIS SHOVEL

4. AN EARLY SHOVEL

5. SHOVELS
Front shovels are used predominately for hard digging above track level and for loading haul units.
Loading of shot rock would be a typical application.

6. STEP 1: BUCKET SIZE
Shovels can usually be equipped with different size buckets. Bottom dump buckets are also available.

7. STEP 1: BUCKET SIZE
Buckets are rated in both heaped and struck capacities.
Both PCSA and SAE use a 1:1 angle of repose for evaluating heaped bucket capacity. CECE specifies a 2:1 angle of repose.
Heaped Capacity is the rating of interest for Production Estimating.

8. STEP 2: FILL FACTOR
The Fill Factor adjusts Heaped Capacity in lcy based on the type of material being handled.
Table 9.1, page 258

9. STEP 2: FILL FACTOR HEAPED BUCKET CAPACITY  FILL FACTOR
= VOLUME (lcy)

10. STEP 3: CYCLE TIME
There are four elements in the production cycle of a shovel:
Load bucket
Swing with load
Dump load
Return swing
See page 260

11. STEP 3: CYCLE TIME
Height of cut affects shovel production. Optimum height of cut ranges from 30 to 50% of maximum digging height, with the lower percentage being representative of easy-to-load materials, such as loam, sand, or gravel. Table 9.2

12. STEP 3: CYCLE TIME
Angle of swing affects shovel production. If the angle of swing is increased, the time for a cycle will be increased, whereas if the angle of swing is decreased, the time for a cycle will be decreased. Table 9.2

13. STEP 3: CYCLE TIME
Ideal production of a shovel is based on operating at a 90° swing and optimum height of cut. The effect of the angle of swing on the production of a shovel is illustrated in Table 9.2.

14. STEP 4: EFFICIENCY FACTOR
When selecting a minutes per hour efficiency factor visualize the work site and consider:
Materials being handled, bank or
broken
Size of the shovels’s dumping target,
(large or small)

15. STEP 5: CLASS of MATERIAL
Production will be in lcy, will need swell factor to adjust to bcy. TABLE 4.3

16. STEP 6: PRODUCTION X Heaped Capacity (lcy) X Fill Factor
X height/swing factor
= Production (lcy/hr)

17. OTIS STEAM SHOVEL