2. Section 1: Earth’s Crust in Motion How Do Stress Forces Affect Rock? The movement of earth’s plates creates powerful forces that squeeze or pull the rock in the crust – these forces are examples of stress Stress – a force that acts on rock to change its shape or volume An earthquake is the shaking and trembling that results from the movement of rock beneath earth’s surface

3. How Does Stress Affect the Earth’s Crust? Deformation – any change in the volume or shape or earth’s crust Three kinds of stress in the crust: – Shearing – stress that pushes a mass of rock in two opposite directions – Tension – pulls on the crust, stretching rock so that it becomes thinner in the middle like warm bubble gum – Compression – squeezes rock until it folds or breaks like a giant trash compactor

4. What Is a Fault? Fault – a break in earth’s crust where slabs of crust slip past each other; These usually occur at plate boundaries

5. a. Most faults lie between the surface and a depth of 70 kilometers b. Focus- point below Earth’s surface where rocks break and move c. Epicenter- point above Earth’s surface directly above the focus

7. What Kind of Faults Are There? Three Kinds: – Normal Faults – Reverse Faults – Strike-slip faults

8. What Are Strike-slip Faults? Strike-slip faults – Shearing forces cause rocks to slip past each other sideways with little up and down Motion; – Ex. San Andreas fault in California

9. What Are Normal Faults? Normal faults – Tension forces cause the rocks to form the fault at an angle – One block is above the fault – Hanging wall – the half of the fault that lies above – Footwall – the half of the fault that lies below – Ex. Rio Grande rift valley

10. Normal Fault

11. What Are Reverse Faults? Reverse faults – compression forces cause the rocks to move towards each other – Same structure as normal fault but the blocks move in opposite direction; hanging wall move up – Ex. Appalachian Mountains and Mount Gould in Glacier National Park

12. Reverse Fault

13. What type of fault? A miner walks on the foot wall and looks up at the hanging wall! A B Normal Fault Reverse Fault Hanging wall moves d o wn Hanging wall moves up

14. Section 2: Measuring Quakes How Does the Energy of an Earthquake Travel Through Earth? Earthquakes – most begin in the lithosphere Focus – the point beneath the earth’s surface where rock that is under stress breaks, triggering an earthquake Epicenter – the point on the earth’s surface directly above the focus

15. What Are Seismic Waves? Seismic Waves – vibrations that travel through Earth carrying the energy released during an earthquake – They move like ripples on a pond – They carry the energy of an earthquake away from the focus, through Earth’s interior, and across the surface – The energy is greatest the the Epicenter

16. What Are the Different Kinds of Seismic Waves? Three categories: – P waves – S waves – Surface waves P waves and S waves are sent out from the focus ; Surface waves develop when the waves reach the surface

17. What Are P Waves? P waves are primary waves – The first waves to arrive – Earthquake waves that compress and expand the ground like an accordion – Cause buildings to contract and expand

18. What Are S Waves? S waves are secondary waves – Earthquake waves that vibrate from side to side as well as up and down – These waves shake the ground back and forth – Shake structures violently – Cannot move through liquids

19. What Are Surface Waves? When P waves and S waves reach the surface some are transformed into surface waves – Surface waves move more slowly than P waves and S waves – Produce the most severe ground movements – Can make the ground roll like ocean waves or shake buildings from side to side

20. How Do Scientists Detect Seismic Waves? Seismograph – records the ground movements caused by seismic waves as they move through the Earth

21. How Do Scientists Measure Earthquakes? There are at least 20 different measures for rating earthquakes, three are: – Mercalli – Richter – Moment Magnitude Magnitude – a measurement of earthquake strength based on seismic waves

22. What Is the Mercalli Scale? Rated earthquakes according to their intensity – Intensity : strength of ground motion in a given place Not a precise measurement Describes how earthquakes affect people, buildings, and the land surface

23. What Is the Richter Scale? A rating of the size of seismic waves as measured by a particular type of seismograph Accurate measurements for small, nearby earthquakes not large, distant earthquakes

24. What Is the Moment Magnitude? A rating system that estimates the total energy released by an earthquake Can be used to rate earthquakes of all sizes, near or far Below 5.0 – little damage Above 5.0 – great destruction

25. Earthquake damage in Charleston

27. February 21, 1916 Asheville, NC - the most intense earthquake in NC history, measuring a 6 on the Mercalli scale. June 5, 1998 an earthquake in Moorseville, NC measured 3.2 on the Richter scale, but there was no reported damage.

29. Mantle- directly above the outer core 1. Plasticity is the property of a solid with the ability to flow like a liquid at very, very slow rates. a. High temperature and pressure allow the rock to flow like a liquid b. This also allows the plates of Earth (lithosphere) to move on the mantle.

31. MANTLE The mantle is composed of silicon, oxygen, iron and magnesium. 3. Moho- boundary between the crust and the mantle. a.Change in the speed of seismic waves moving through the Earth led to its discovery. b. Discovered in 1909 by a Yugoslav scientist, Andrija Mohorovicic.

32. How Do Scientists Locate the Epicenter? Geologists use seismic waves – P waves arrive first – S waves arrive close behind – Scientist measure the difference in arrival times The farther away an earthquake is the greater the time between their arrival – Scientists draw three circles using data from seismographs set at different stations to see where they intersect – the epicenter