1. The Efficiency of Flexible Solar Panels and Changes in the Earth’s Magnetic Field at Altitude

2. Vehicle Summary Total length of 116.5 inches 4.0” Airframe (3.9” Inside diameter) BlueTube 2.0 Separates into three sections Top Nosecone Payload Flip-Out Rotor Blades Middle Drogue Parachute Altimeters Housing for Rotor Blades Bottom Main Parachute Motor (Plugged) Fins

3. Payload Summary Studying the efficiency of flexible solar panels, and changes in power output Also investigating changes in the earth’s magnetic field Housed in the Modular Payload System (explained later)

4. Vehicle Changes Recent delays in funding have delayed parts orders and some parts have gone out of stock –Aerotech K700 motor now Aerotech K828 –Aerospace composite fins now fiberglass covered birch plywood –Ejection canisters will be made and not bought –Piston removed on drogue parachute compartment Design changes from subscale problems –Ejection charge holders have been added –Vertical Wind Turbine has been replaced with flip out rotor blades

5. Payload Changes The LabPro data logger does not support a data trigger Exchanged for a custom built LabQuest data logger from Vernier at no charge The proper amount of resistance has been researched and verified by manufacturer –77 Ohms of resistance instead of previous 40 Ohms

6. Motor Selection Aerotech K828 FJ 54/2560 mm casing Change was made because K700 Motor was out of stock from multiple vendors MotorManufacturer Total Impulse (N- sec) Max Thrust (Newtons) Burn Time (s) Average Thrust (Newtons) Thrust to Weight Ratio K828AeroTech2120.01,303.8 N2.508288.64

7. Estimated Rocket Performance Estimating a coefficient of drag of around 0.60 Estimated dry weight of 16.37 pounds Rocket Coefficient Of Drag 0.350.400.450.500.550.600.650.700.75 Rocket Weight (without motor) 14.00719468676575631260755859566154795311 14.50697966756402615659335729554253705210 15.00676864856231600157915599542252595108 15.50656062986061584656495468530151485004 16.00635761145894569355085338518150354900 16.50615959345729554153685208506049234794 17.00596657575566539152295079494048114689 17.50577755845407524350924952482146994584 18.00559454125251509949574826470345884480 18.50541752515098495748254701458644784376 19.00524550914950481746944579447143694273 Note: Simulations calculated with 5 mph winds

8. Motor Thrust Curve

9. Rocket Flight Stability Margin Center of gravity 73.4 inches from nose Center of pressure 87.5 inches from nose Stability margin of 3.50 calipers Stability of 4.86 calipers after burnout CG Position: 73.4 inches from nose CP Position: 87.5 inches from nose Stability Margin: 3.50

10. Thrust to Weight Ratio Thrust to weight ratio is 8.64 to 1 High acceleration of approx. 459 m/s 2 (14 g’s) Acceleration (ft/s 2 ) vs. Time (s)

11. Rail exit velocity 8 ft Rail = 75.0 ft/s 10 ft Rail = 83.3 ft/s 12 ft Rail = 90.8 ft/s Planned to launch using a 10 ft rail Lugs compatible with Standard 1” Black Sky Rails

12. Parachute Sizes and Descent Rates Drogue parachute: 24 inch diameter TAC-1 Four flat strap nylon suspension lines Deploys at Apogee (backup charge 2 seconds later) Estimated descent rate of 82 ft/s Swivels are attached to each parachute Additional swivel attached to drogue mount

13. Parachute Sizes and Descent Rates Main parachute: 84 inch diameter TAC-1 Four flat strap nylon suspension lines Deploys at 700 feet (backup charge at 500 feet) Estimated descent rate of 19 – 20 ft/s Drift in 5 mph= 500 feet Drift in 10 mph= 900 feet Drift in 15 mph= 1800 feet Large Margin of Error

14. Test Plans and Procedures BlueTube airframe was able to withstand 300 pounds of force of compression without signs of failure 350 degrees for 30 minutes = ⅛” increase in circumference Freezer for 30 minutes = No notable change Underwater for 30 minutes = Tube began to wrinkle 2 hours in sun = 1/16 th inch bend across 4 feet

15. Test Plans and Procedures A 3/16 th inch birch plywood bulkplate withstood 200 pounds of force before test was stopped –Force was applied by stepping on exposed plate –Plate was permanently warped 1/8 th inch across diameter Birch Plate Clamp Force

16. Test Plans and Procedures All sensors for payload have been verified and function as planned –Sensors must be zeroed before use for best results Accelerometer –Held up for 5 seconds, down for 5, shook, then hit against palm

17. The magnetic field sensor was rotated clockwise to check functionality Peak readings when pointed to magnetic south (geo graphic north) as expected Does not appear to be affected by other sensors Test Plans and Procedures

18. Solar panel, current probe, and voltage probes have been tested –Test was done in evening sun –Not optimal power output –Solar panel was 50% covered, then roughly 90% bcovered, then fully covered Test Plans and Procedures

19. Remaining tests: –Ejection charge deployment test Procedure explained later –Solar panel test in full sun With 77 ohms of resistance, current and voltage probes –Fin strength test Identical to bulkplate test Test Plans and Procedures

20. Scale Model Flight Test Two half-scale flights have been conducted One ejection charge test before flight Aerotech H180 3.5 Stability margin Two straight flights without any wobble Set up for dual deployment

21. Scale Model Flight Test First launch reached 2403 feet Second launch reached 2313 feet After launch conditions were put into Rocksim Estimated drag coefficient of 0.45

22. Scale Model Problems First launch blew a hole in the main airframe (no main parachute) –Cause due to no ejection charge canister support Second launch separated for main parachute, but parachute did not deploy -Cause due to use of Pyrodex/ not enough black powder -Extensive ground testing will be completed with 4F black powder for full-scale

23. Scale Model Problems First launch carried a vertical wind turbine –Slow, inconsistent spin Second launch carried flip out rotor blades –Fast consistent spin, but shock cord caught under blade and twisted

24. Scale Model Problems Rotor blade cracked –Higher grade propeller will be used for full scale Shock cord heavily twisted –Shock cords will be better packed use a rubber band to contain cords for organization

25. Dual Deployment Avionics Test Completed on Monday, December 13 th Altimeters placed in a vacuum chamber Both altimeters showed a drogue and main deployment

26. Ejection Charge Amount test Status: In planning Calculated 3.1 grams for main, 2.3 for drogue Calculating for 300 pounds of force or 23.9 psi Plenty of force to break three 2.5 mm styrene shear pins 6 total ground tests will be performed

27. Ejection Charge Amount Test Start test with ejection charges sized below calculated amount Rocket will be mounted horizontally Ballast will be used to simulate actual weights Test must clearly eject and pull out parachutes

28. Payload Integration Feasibility All sensors and data logger are made by Vernier Software and Technology Data logger is also power source for all sensors LabQuest has been modified by Vernier to fit into the payload airframe To retrieve data the data logger unit must be retrieved

29. Payload Integration Feasibility All units contained in the Modular Payload System (MPS) Constructed out of birch plywood Two ¼” threaded steel rods for structural integrity Excess wiring will be coiled and stored in bottom section of MPS Slots cut in bulkplates to allow for wiring to pass from one section to another Must be installed facing specific direction to slide over solar panel wiring

30. Modular Payload System

31. Removal of the MPS Nosecone must be removed A strap will be connected to the two stainless steel rods the can be used to pull out the MPS When the mid section is exposed the wires from solar panel are disconnected The entire unit is taken to computer for data retrieval via USB cable

32. Educational Engagement Plan Status “To Apogee and Beyond” Project currently in progress High schools students will learn about the basics of rocketry –Will design and make fins for a partially designed rocket in Rocksim –Working in groups of 2 or 3, they will assemble their rocket Large scale launch day on February 27 th where the 200+ students will launch their rockets Launch site at Local ranch: Tate Farms

33. Educational Engagement Plan Status Visiting the local middle school’s aeronautics class –Status: Scheduled for first week of February Visiting local elementary school’s science night and will give presentation –Status: In development

34. Questions?