1. Solid State Morphing Aircraft Team Members: Roger Bounthisane Elaine Gumapas Amber Cook Thoai Nguyen Jeremiah Silvis James Bird MAE 435 April 3, 2014 Status Update Presentation1

2. Objectives and Constraints w1 c1 w2 Θ1Θ1 Prove the feasibility of smart materials in ornithoptic flight in cruise conditions Use only solid state smart materials Use a one piece wing surface

3. Group Structure MAE 435 April 3, 2014 Status Update Presentation3

4. Aerodynamics – Wing Designs MAE 435 April 3, 2014 Status Update Presentation4

5. FEA Complex Wing Design MAE 435 April 3, 2014 Status Update Presentation5 Different load cases examined:  Distributed load over the surface area  Distributed load along the edge  Pointed load at the end  Natural Frequency Testing various thicknesses in different locations of the wing

6. Structures - Fuselage Prototype Capable of a 6.5lbf payload Light weight design~ 38g Does not need aerodynamic design 1 st iteration is designed with poster board. Final design will be carbon fiber reinforced

7. Structures – Four Bar Linkage MAE 435 April 3, 2014 Status Update Presentation7

8. Smart Materials MFC

9. Macro Fiber Composite Testing LabView Program for Static and Dynamic MFC Testing

10. Controls/Electronics The Arduino UNO was used for prototyping, and the Zduino LEE is being fitted and prepared for the fuselage. Bimorph signal generation, with fault safety, and frequency display.

11. Future Work Construct a wired controller Perform MFC test with Arduino controller Install Zduino LEE in fuselage

12. MAE 435 April 3, 2014 Status Update Presentation12