1. Current Mirrors

2. OUTLINE Cascode Stage (cont’d) Current Mirrors Reading: Chapter 9.2
supplementary remarks
Current Mirrors
Reading: Chapter 9.2

3. Review: Cascode Stage Rout
The impedance seen looking into the collector can be boosted significantly by using a BJT for emitter degeneration, with a relatively small reduction in headroom.

4. Temperature and Supply-Voltage Dependence of Bias Current
Circuits should be designed to operate properly over a range of supply voltages and temperatures.
For the biasing scheme shown below, I1 depends on the temperature as well as the supply voltage, since VT and IS depend on temperature.

5. Concept of a Current Mirror
Circuit designs to provide a supply- and temperature-independent current exist, but require many transistors to implement.
 “golden current source”
A current mirror is used to replicate the current from a “golden current source” to other locations.

6. Current Mirror Circuitry
Diode-connected QREF produces an output voltage VX that forces Icopy1 to be equal to IREF, if Q1 is identical to QREF.
Current mirror concept
Generation of required VBE
Current Mirror Circuitry

7. Bad Current Mirror Example 1
If the collector and base of QREF are not shorted together, there will not be a path for the base currents to flow, so that Icopy is zero.

8. Bad Current Mirror Example 2
Although it provides a path for base currents to flow, this biasing approach is no better than a resistive voltage divider.

9. Multiple Copies of IREF
Multiple copies of IREF can be generated at different locations by applying the current mirror concept to multiple transistors.

10. Current Scaling
By scaling the emitter area of Qj by a factor of n with respect to the emitter area of QREF, Icopy,j is scaled by a factor of n with respect to IREF.
This is equivalent to placing n unit-sized transistors in parallel.

11. Example: Scaled Currents

12. Fractional Scaling
A fraction of IREF can be created in Q1 by scaling up the emitter area of QREF.

13. Example: Different Mirroring Ratios
Using the concept of current scaling and fractional scaling, Icopy1 = 0.05mA and Icopy2 = 0.5mA, derived from a single 0.2mA reference current source (IREF).

14. Effect of Base Currents

15. Improved Mirroring Accuracy
Use QF (rather than IREF) to supply the base currents of QREF and Q1, reduce the mirroring error by a factor of .

16. Different Mirroring Ratio Accuracy

17. PNP Current Mirror
A PNP BJT current mirror can be used as a current-source load for an NPN BJT amplifier stage.

18. Generation of IREF for a PNP-BJT Current Mirror
Neglecting base currents, the currents flowing through QM and QREF2 are the same.

19. Current Mirror with Discrete BJTs
If QREF and Q1 are discrete NPN BJTs, IREF and Icopy1 can differ dramatically, due to IS mismatch.