1. The Role of Groundwater in Geologic Hazards W. Richard Laton, Ph.D., RG Assistant Professor, Department of Geological Sciences, CSUF

2. Natural Hazards Almost every imaginable natural hazard exists in Southern California. Southern California is a complex area of differing geologic and hydrologic conditions representing many differing hazards. Hazard identification defines the magnitude and associated probabilities of natural hazards that may pose threats to human interests in specific areas.

3. Why do we need to study Natural Hazard Areas? Planning! Where (Identification) Why (Understanding the system) What can we do (mitigation) Prevention

4. Who’s affected 35 million California citizens City, County and State Regulators Builders and Contractors Businesses

5. GIS and Natural Hazards Through the advanced utilization of GIS, maps of Engineering geology, shallow groundwater, surface water, liquefaction, subsidence, and landslide susceptibility can be produced.

6. Groundwater Groundwater is usually the lost component when it comes to defining hazards. Through GIS, groundwater becomes an important player in hazard management. Susceptibility maps of Liquefaction, Subsidence and Landslide prone areas

7. Example of Regional Groundwater Maps Riverside County shallow groundwater map was derived from over 12,000 water well records Used for Liquefaction and Subsidence maps

8. Problems with Regional Groundwater Maps Comprised of incomplete well records Incomplete well completion records Not enough coverage area Lack of aquifer information

9. Deep wells vs. Shallow wells Water levels less than 50-feet of most importance Most regional maps based on deeper wells Shallow well records come primarily from environmental investigations

10. Natural Hazards Liquefaction Subsidence

11. Groundwater and Hazard Identification Liquefaction – water within 50 feet of surface Liquefaction – over watering/irrigation Subsidence – groundwater withdrawal

12. Liquefaction Susceptibility Derived from Groundwater and Engineering Geology maps Identifies susceptible conditions in 4 general categories Used for geotechnical design-level studies Used for Zoning and Loss estimation analysis

13. Causes Shallow groundwater + fine grained materials + earthquakes Over watering - irrigation + fine grained materials + earthquakes

14. Liquefaction Flow Chart

18. Subsidence Susceptibility Derived from Groundwater and Engineering Geology maps Identifies susceptible conditions in 2 general categories Used for geotechnical design-level studies Used for Zoning and Loss estimation analysis

19. Engineering Geologic Materials Map of Temecula, California

20. Shallow Groundwater Map of Temecula, California

21. Subsidence Susceptibility Map, Temecula, California

22. Subsidence Un-regulated groundwater withdrawal Hydro compaction – Hydro consolidation Oil or gas withdrawal

23. What can we do better? Better well records Better logging techniques Sharing of records and data Central housing of all records Use regional maps for what they were intended

24. Conclusions Regional maps should be only used for gross planning purposes More detailed groundwater information is needed for less populated locations Need for better information gathering during soil and groundwater investigations