1. TSX C USB FIP USB Fipway offer, installation and configuration
Automation - End User Solutions
Quality & Customer
TSX C USB FIP USB Fipway offer, installation and configuration 1

2. TSX C USB FIP Communication Adapter Offer Description
A TSXCUSBFIP adapter with its USB connection
An installation guide
But to use the adapter the following items are required :
A TSXFPCG010 or TSXFPCG030
To be ordered separately.
A Fipway driver.
Included in the CD driver (ref : TLXCDDRV20M V2.5 or higher). you can download it from the Telemecanique web site ( 2

3. TSX C USB FIP Communication Adapter Offer Description bis
But that will not be enough other requirement regarding the Compatibilities exist.
Schneider Software
Unity V3.1 or Higher
PL7 V4.5 SP4 or Higher
If you respect all these recommendations you will be able to :
Fipway
Connect your PC to a remote PLC
Upload or Download application
Fipio / WorldFip 2

4. TSX C USB FIP Communication Adapter How to install it
Install the Fipway driver. (The driver must be install before connecting the adapter)
Insert the USB cable from the adapter into the USB port on your PC
The USB and ERR LEDs will light
Messages will pop up
“Found New Hardware”
“Welcome to the Found New Hardware Wizard” window will open. Select “No, Not this time” and click Next
Select Install the software automatically and click Next
Click Finish
If this is the first time the adapter has been plugged into the system; the “Found New Hardward” message will pop up again and you will have to repeat all steps above.
The last message should be “New Hardware is ready to use” .

5. TSX C USB FIP Communication Adapter How to configure it
Open Schneider Drivers Manager
Select the USB-FIP Driver
Configure the Fipway or Fipio Networks Parameters
(We can configure two adapters on one PC, UFP01 / UFP02)
Setting MB+ address, Peer Cop or not,