1. DHCP Configuration of IPSEC Tunnel Mode Draft-ipsec-dhcp-05.txt Bernard Aboba Microsoft

2. Outline Configuration Requirements Security Requirements DHCP usage Address pool selection Walkthrough Summary

3. Configuration Requirements To obtain an IP address and other configuration parameters appropriate to the class of host To reconfigure when required To support failover –Want to be able to maintain address/configuration state between VPN server failures To integrate with existing IP address management facilities such as DHCP –Want single point of address and configuration management

4. Security Requirements To support address pool management –Examples Extranet where vendors, contractors, employees have different access levels, allocated out of different address pools Intranet where sales, marketing, engineering have different quality of service levels, allocated out of different pools To authenticate where required –Since DHCP server typically not co-located with VPN server, can’t assume access to IKE credentials –DHCP authentication required to prove claim of identity in the client-identifier-option

5. DHCP Packet Body Hardware address length (hlen), hardware type (htype), client hardware address (chaddr) –Should be unique to the segment client is connecting to –Hardware identifier tells VPN server/DHCP relay which VPN interface to forward DHCP messages to Client-identifier-option isn’t returned by DHCP server –LAN: Use interface hardware address –Dialup: Use outer IP address + 2 random octets Not consistent between reboots Should a different htype be used for VPN? –Would make it easier for DHCP server to distinguish VPN clients

6. DHCP Options Client-identifier-option –Must be unique to client –Consistency between reboots needed –Can use Htype/Chaddr combination as suggested in RFC 2132 In dialup case, not consistent between reboots –Makes it difficult to support user or machine specific policies –Can use FQDN or NAI Consistent between reboots Makes it easier to administer DHCP authentication Classless static route option –Draft-ietf-dhc-csr-00.txt –Replacement for RFC 2132 static route option

7. Address Pool Selection Support for existing methods for address pool selection –Client hardware address –Client-identifier option –Vendor-class-identifier option –Vendor-specific information option –Relay agent option –User class option –Host name option –Authentication option Can leverage conditional behavior of popular DHCP servers DHCP (even with authentication) is not an Access Control mechanism –Shouldn’t use address assignment as a way of restricting access; client can just choose its own IP address and get around the restrictions

8. Walkthrough The remote host establishes an IKE MM or AM security association with the VPN server. The remote host establishes a DHCP tunnel mode QM SA with the VPN server. –Filters From client to server: Any to Any, destination: UDP port 67 From server to client: Any to Any, destination: UDP port 68 DHCP messages are exchanged between the remote host and the DHCP server, using the VPN server as a DHCP relay, configuring the intranet interface of the remote host. –Security gateway needs to snoop the DHCPACK to learn the IP address assigned to the VPN interfaces The remote host MAY request deletion of the DHCP SA or the remote host and VPN server MAY continue to use the same SA for all subsequent traffic by adding temporary SPD selectors as with name ID types. The remote host establishes a tunnel mode SA to the VPN server in a quick mode exchange.

9. L2TP IPSEC Tunnel Mode Authenticated Tunnels IPSEC IPSEC Authenticated Calls Yes Yes Integrity Protection IPSEC IPSEC KeepaliveLCP, L2TPIKE NAT friendlinessNoYes (w/QM restrictions) Address Allocation IPCP DHCP Configuration DHCPINFORMDHCP Multiprotocol YesNo Encryption IPSEC IPSEC Compression PPP or IPPCP IPPCP Routing protocolsYesYes, if treated as interface IPSEC Remote Access Protocol Comparison