1. Honda Fit Turbo Kit Installation Manual

2. Take off windshield wiper

3. Take this part off

4. Take off the engine of windshield wiper

5. Uninstall the protecting hood

6. Take off the front bumper ＺＡＧＥ

7. Take off the stock manifold

8. Remember to keep the stock O 2 Sensor that you take off

9. Take off the stock mid-pipe

10. Remember to keep the stock O 2 Sensor that you take off

11. Install manifold on the turbocharger

12. Please note this particular bolt should be locked from the bottom up, so it doesn’t block another bolt beside it. Other 3 bolts are locked the normal way from top.

13. Install the silicon hose first, remember the turbo clamp, too

14. Turbocharger can be installed from this angle

15. Connect compressor housing inlet and air filter with Aluminum pipe Lock up spot

16. Please assemble the pipes according to the specified order above ３ ２ １ ４ ５

17. Aluminum Pipe 1 1 Lock up spot

18. Aluminum Pipe 2 ２

19. Aluminum Pipe 3 Lock up spot ３

20. Install intercooler, please pay attention to the 3 lock up spots.

21. Aluminum Pipe 4 ４ Lock up spot

22. Aluminum Pipe 5 Install blow off ５ Install the smaller air filter

23. Install vacuum pipe Blow off MAP sensor Set up of aluminum pipe and vacuum pipe

24. Install oil feed line Please lock it tight to prevent oil leakage

25. Oil feed line set up

26. Connection of oil feed line on the engine side

27. Install oil drain pipe

28. Install front pipe

29. Install mid pipe Connect O 2 Sensor onto mid pipe first, then install both onto to car

30. Remember to connect O 2 Sensor

31. Install the protecting hood back up

32. Install engine of windshield wiper back up

33. Put the cover back

34. Install windshield wiper back on

35. Put the front bumper back ＺＡＧＥ

36. THE END