1. Fabrication Guide Triten Range Of Products

2. Cutting

3. Four Methods Of Cutting Plasma Arc Water Jet Carbon Arc Abrasive Saw NOT by oxy-gas

4. Plasma Arc Cutting Recommended method. Material can be cut with hand-held model (inexpensive) Plates can be cut from either side Consider plasma arc taper High definition plasma for greater precision Angled torch for countersunk holes

5. Cold Forming

6. Material can be pressed or rolled with care

7. Cold Forming Rolling always in the same direction as the overlay beads. Convex recommended Concave with great care Pressing always with a radiused tool, never with a “knife”

8. Fixing Holes

9. Methods of attachment Material cannot be mechanically drilled or countersunk using traditional methods Either : –Plug welding –Stud Welding –Countersunk bolts –Pre-machined inserts

10. Fixing Holes Direct plasma arc piercing gives a perfectly acceptable hole quality for most applications A machined insert can be welded in place but is often a more expensive method

11. For further information, refer to the Triten Fabrication Guide