1. Equipment Setup GCS300 – GCS900 Components Presented By:

2. Grade Control Systems Common Platform The GCS product family is built on a common architecture / platform  CAN based communications  Common harnesses  Common sensors  Common components  Common hydraulic valves Power module Valve module Harness

3. Grade Control Systems Product Line Levels Two distinct functionality levels  Each with a different operator interface Conventional Slope sensors Angle sensors Sonic tracers Laser receivers 3D Slope Sensors Angle Sensors Sonic Tracers Laser Receivers ATS Targets GPS+GLONASS Receivers Laser Augmentation Trimble CB410 Trimble CB420 Trimble CB430

4. Power module Valve module Trimble GCS300: Conventional Dozer – Elevation or Blade-slope Harness Trimble CB420 or LaserSlope or

5. Power module Valve module Trimble GCS400: Conventional Dozer – Elevation & Blade-slope Harness Trimble CB420 or Dual LaserLaser & Slope or

6. Mainfall sensor Blade-Slope sensor Rotation sensor Power module Valve module Trimble GCS500: Conventional Grader - Cross-slope only Harness Trimble CB420

7. Power module Valve module Trimble GCS900: Elevation & Blade-slope Harness Laser & Slope or Dual Laser Trimble CB430 Light bars

8. Blade-slope sensor Power module Valve module Trimble GCS900: 3D ATS & Blade-slope Harness Trimble CB430ATS TargetRadioLight bars Mainfall sensor Rotation sensor

9. Mainfall sensor Blade-slope sensor Rotation sensor Power module Valve module Trimble GCS900: 3D GPS & Cross-slope Harness Trimble CB430GPS+GLONASSRadio Light bars Sonic (opt)

10. Power module Valve module Trimble GCS900: 3D Dozer - Dual GPS Harness Trimble CB430 Dual GPS +GLONASS RadioLight bars

11. Trimble GCS600: Conventional Excavator – Depth & Slope Trimble CB410 Harness Boom AS450 Bucket AS450 Stick AS450 LC450 (opt) Tilt-bucket AS450 (optional) Platform AS460 VA Boom AS450 (optional) Laser (opt) (Replaces stick sensor)

12. Trimble GCS900: 3D Excavator - Dual GPS Trimble CB430 Dual GPS +GLONASS RadioLight bars Harness Boom AS450 Bucket AS450 Stick AS450 Tilt-bucket AS450 (optional) Platform AS460

13. Do’s and Don’ts

14. Measure Up

15. What’s involved?? Measure Up Tools Machine Settings Machine Dimensions – Blade Height – Blade Width between Tips – Machine Body Dimensions Mast Measurements – In from Blade Tip – Back from Cutting Edge Bolts – Above Cutting Edge Bolts

16. Why is it important?? Measurements are from Receiver Measurements are Machine specific Allows for Proper Tip Measurements – Correct Grade – Correct Location

17. Blade Wear

18. Why it Important?? – Affects the Measure Up – Grade Accuracy of Machine What is Blade Wear?? – Cutting edge of blade being worn down When Should it be Measured?? – Dependent on material – Minimum - 1 month – Max - As the operator deems necessary How do I measure it??