1. Electric Current and Direct- Current Circuits
Chapter 22, 23
Electric Current and Direct- Current Circuits

2. Units of Chapter 22 and 23 Electric Current and circuit
Resistance and Ohm’s Law
Energy and Power in Electric Circuits
Resistors in Series and Parallel
Ammeters and Voltmeters

3. What would happen?
More electric potential difference - more charges move
Video - electric current animation 3 3

4. Electric current
The flow of charge particle from one place to another.
The electric current is defined the rate of
flow of electric charge. 4 4

5. What do you need to light a bulb?5 5

6. Electric circuits - A closed path through which charge can flow, returning to its starting point.
Conventional current – the flow of + charge 3

7. Electric Current
The direction of current flow – from the positive terminal to the negative one.

8. Electric Current
A battery uses chemical reactions to produce a potential difference between its terminals. It causes current to flow through the flashlight bulb similar to the way the person lifting the water causes the water to flow through the paddle wheel.

9. Electric Power Power – the rate of energy
A generator transfers kinetic energy to electric energy each seconds. 4

10. The electric power
The Electric Power – the product of the current and the potential difference. 6

11. Example
A 120 V motor operates at 13 A. Determine the power and the energy used in one hour of operation.
Page 594 # 1-5 10

12. Resistance and Ohm’s Law
Ohm's law states that the current through a conductor between two points is directly proportional to the potential difference across the two points.

13. Resistance and Ohm’s Law
Resistance – the property determining how much current will flow.
Solving for the resistance, we find
The units of resistance, volts per ampere, are called ohms:

14. Check Your Understanding
Which of the following will cause the current through an electrical circuit to decrease? Choose all that apply.
a. decrease the voltage
b. decrease the resistance
c. increase the voltage
d. increase the resistance 14

15. Check Your Understanding
If the resistance of a circuit were tripled, then the current through the circuit would be ____.
a. one-third as much
b. three times as much
c. unchanged
d. ... nonsense! There would be no way to make such a prediction. 15

16. Resistance and Ohm’s Law
Two wires of the same length and diameter will have different resistances if they are made of different materials. This property of a material is called the resistivity.

17. Resistance and Ohm’s Law
The difference between insulators, semiconductors, and conductors can be clearly seen in their resistivities:

18. Use the Ohm's law equation to determine the missing values in the following circuits.18

19. Some circuit symbols used in schematic diagrams are shown below.19

20. Energy and Power in Electric Circuits
In materials for which Ohm’s law holds, the power can also be written:
This power mostly becomes heat inside the resistive material.

21. Energy and Power in Electric Circuits
When the electric company sends you a bill, your usage is quoted in kilowatt-hours (kWh). They are charging you for energy use, and kWh are a measure of energy.

22. Ammeters and Voltmeters
An ammeter is a device for measuring current, and a voltmeter measures voltages.
The current in the circuit must flow through the ammeter; therefore the ammeter should have as low a resistance as possible, for the least disturbance.

23. Ammeters and Voltmeters
A voltmeter measures the potential drop between two points in a circuit. It therefore is connected in parallel; in order to minimize the effect on the circuit, it should have as large a resistance as possible.

24. Summary Electric current is the flow of electric charge. Unit: ampere
1 A = 1 C/s
A battery uses chemical reactions to maintain a potential difference between its terminals.
The potential difference between battery terminals in ideal conditions is the emf.
Work done by battery moving charge around circuit:

25. Summary
Direction of current is the direction positive charges would move.
Ohm’s law:
Relation of resistance to resistivity:
Resistivity generally increases with temperature.
The resistance of a superconductor drops suddenly to zero at the critical temperature, TC.

26. Summary
Ammeter: measures current. Is connected in series. Resistance should be as small as possible.
Voltmeter: measures voltage. Is connected in parallel. Resistance should be as large as possible.