1. Floral Design Bud Vase Construction
Step – by – Step Directions

2. Step 1: Select Materials
1 long-stem rose or 1 carnation (any color)
2-3 stems leatherleaf
1 stem baby’s breath or other filler flower
Other Foliage (Optional)
1 ½ yards #3 ribbon
Wire
Floral Tape
Bud Vase
Card and Pick

3. Step 2: Fill Vase with Water
Fill bud vase with preservative water to within 2 inches of the top.

4. Step 3: Remove Lower Foliage
Remove all foliage and thorns that will be under water to prevent rot and ethylene gas.

5. Step 4: Cut the Flower Stem
Cut the flower stem to a height of 1 ½ to 2 times the height of the vase.

6. Step 5: Wire the Rose Use 22 gauge wire Use the straight-wire method
Gradually wrap wire around the stem, being careful not to break off leaves
Do NOT tape

7. Step 6: Insert the Flower into the Vase
Place the rose in the vase
Turn the most desirable side outward.

8. Step 7: Add Foliage
Select 2 pieces of leatherleaf that are slightly taller than the flower
Place these behind the flower
They should be triangular in appearance and may bend slightly away from the flowers

9. Step 8: Add Baby’s Breath
Add a sprig of baby’s breath
Baby’s breath should surround the rose inside of the foliage

10. Step 9: Make and Insert a Bow
Make a bow using #3 ribbon
Bow color should match flower
Bow should have four to five loops
Attach bow to a pick
Insert the pick into the front of the vase

11. Step 10: Refrigerate
Place the completed vase in the cooler or refrigerator to help preserve the flowers.

12. Step 11: Clean up the Work Area
Put away all materials
Sweep and clean the work area

13. Congratulations! You Did a Great Job