1. Tweaking Your Simon Adding a photoresistor and changing code Instruction by Pete Lewis

2. Demo over view: Arduino Software and Arduino hardware Uploading different code onto the Simon Disco Mode Code found: www.sparkfun.com/tutorials/203 Adding a photocell and using Disco Mode

3. Downloading the Arduino Environment: First go the Arduino website: http://www.arduino.cc/ Then click on Download and follow the instructions

4. Hardware: You will need the following: A USB cable, an FTDI Breakout Board, and six pins of Break Away Headers

5. Break Away Headers: Headers come in strips of forty We just need six for the FTDI Breakout Board so clip off six of the forty by cutting through the seventh pin

6. FTDI and Headers: Attach the FTDI Basic Breakout Board and Headers Make sure you plug the long side of the headers into the FTDI Breakout Board:

7. Plugging it All into the computer: Plug the USB cord into the computer and then into the FTDI Board The TX and RX LEDs will blink as you plug the FTDI in, this means the FTDI is talking to your computer

8. Plugging it All into the Simon: Plug the Headers on the FTDI Board into the Programming Port on the Simon

9. Plugging it All into the Simon: Orient the FTDI properly, GRN goes to GRN and BLK goes to BLK Also make sure to hold the FTDI at a 45 degree angle so the Headers make contact with all the ports

10. Before uploading code onto the Simon: Open the Arduino Environment Choose your board type and serial port

11. Uploading Code onto the Simon: We're finally ready to upload code Open the Simon sketch in the Arduino Environment and click Upload

12. Adding a Photoresistor to the Simon: We're ready to add a sensor to your Simon! You'll need a photoresistor and a plain old 10K Ohm resistor:

13. Here's the Schematic: This schematic shows the three connections we will have to make 5V, GND and A0

14. The Simon Analog Pins The three holes (5V, GND and A0) you will connect to the photoresistor circuit

15. Creating the Circuit Make the photoresistor and regular resistor look like the schematic

16. Creating the Circuit Make the photoresistor and regular resistor look like the schematic

17. Connecting the Circuit Just prior to soldering your photoresistor circuit should look like this

18. Connecting the Circuit Just after soldering your photoresistor circuit should look something like this

19. Connecting the Circuit Just after soldering your photoresistor circuit should look something like this

20. Bending the Sensor Bend the photoresistor around so it faces your light source

21. Insert Your Batteries and Bask in the Glory of Disco Mode

22. www.sparkfun.com 6175 Longbow Drive, Suite 200 Boulder, Colorado 80301