1. Ball Kicker By: Makiya Phillips Malakai Brown Gaby Paoletti

2. Step #1

3. Step#2

4. Step #3

5. Step #4

6. Step #5

7. Step #6

8. Step #7

9. Step #8

10. Step #9

11. Step #10

12. Step #11

13. Step #12

14. Step #13

15. Step #14

16. Step #15

17. Step #16

18. Step #17

19. Step #18

20. Step #19

21. Step #20

22. Step #21

23. Step #22 Make Sure the Project Is Facing The Correct Way.

24. Step #23

25. Step #24

26. Step #25

27. Step #26

28. Step #27

29. Step #28

30. Step #29

31. Step #30

32. Step #31

33. Step #32

34. Step #33

35. Step #34

36. Step #35

37. Step #36

38. Step #37 Connect the two motors to ports B and C on the NXT. It doesn't matter which is which

39. Step #38

40. Step #39

41. Step #40 Connect the third motor to port A on the NXT, and route the wire under the 5- hole beam as shown left.

42. Step #41

43. Step #42

44. Step #43 Connect the touch sensor wire to port 4 on the NXT.

45. Step #44

46. Step #45

47. Step #46

48. Step #47

49. Step #48

50. Step #49

51. Step #50

52. Final Product Should Look Like This

53. Hope You Had Fun Building! You Will Need A Small Ball So It Can Kick It!