1. Phenom Program Manager
Establishing a flow
Sven Lepschy
Phenom Program Manager

5. COCKPIT SAFETY INSPECTION
Check all switches and controls are correctly set, control locks removed and seats/belts in good condition in preparation to provide ‘Power’ to the aircraft safely.
COMPLETE COCKPIT SAFETY INSPECTION CHECKLIST

6. BEFORE START NAV LIGHT - On GPU AVAILABLE Yes No
BATT 1 & 2 Voltage - 24 Volts Minimum
Engine 2 - Start
ATIS / IFR Clearance
MFD - “Fly The Line Run With Sven”
FLT Plan, Temp C°, LFE, Radar, Weight, Speeds/ Status
PFD - Nav / Comm / ALT / Baro / HDG / XPDR, etc
Thrust Lever – Idle
Emergency/Park Brake - SET
COMPLETE BEFORE START CHECKLIST 1 3 2 4 5
SID brief: confirm selected RWY, SID and transition. Identify each individual waypoint by reference to JEPP plate. Include tracks and distances.

7. DATA ENTRY ON G1000 (FTLRWS)

8. AFTER START 6 GPU Disconnect ELEC EMER Button - PUSH IN
Batteries 1 & 2 Voltage - CKD
2. Controls - CKD FREE / Normal Pitch Trim
3. Trims – Roll, Yaw & BKP Pitch Trim
4. Flaps - SET T/O
5. SWPS (TEST Panel) - TEST
COMPLETE AFTER START CHECKLIST
Departure brief
Emergency Brief
Taxi brief
6. TAXI Light - ON (When ready to taxi) 2 5 3 1 4

9. BEFORE TAKEOFF 4 2 1 SIGNS/OUTLET - PED-Belts/Off Passengers advise
CAS Messages checked
Takeoff configuration - CKD “OK”
External Lights – “As Required”
COMPLETE BEFORE TAKEOFF CHECKLIST
Cleared to enter runway - Strobe & Landing Lights - ON 3

10. Thank you