1. Measurement of Pressure Manometry
• Use liquid column in vertical or inclined tubes
• Hg barometer is an example of one type of manometer
• Measure
• 3 common types of manometers including the U-tube
manometer, piezometer, inclined manometer Measurement
of Pressure Manometry

2. •Piezometer is simple and accurate
•Piezometer is only suitable if the
pressure in the container is greater
than atmospheric pressure
•Fluid in the container in which the
pressure is measured must be a
liquid rather than gas
Figure 2.9 (p. 51)
Piezometer tube.

3. Figure 2.10 (p. 51)
Simple U-tube manometer.

4. Example 1
A manometer is used to measure the pressure in tank as shown. If the local atmospheric pressure is 96 kPa, determine the absolute pressure within the tank.

5. Example 2 A closed tank contains compressed air and oil (SGoil=0.90)
as Is shown in the Figure. h1=36 in., h2=6 in, h3=9 in.
Determine the pressure reading (in psi) of the gage using
the U-tube Hg manometer

6. Figure 2.11 (p. 53) Differential U-tube manometer.
• suitable to measure the pressure
difference between two points

7. Figure 2.12 (p. 54) Inclined-tube manometer
Suitable to measure small pressure changes
Often used to measure small difference in gas pressures

8. Other Pressure Measurement Devices
• Mechanical and electronic pressure measuring devices
Figure 2.13 (p. 55)
(a) Liquid-filled Bourdon pressure gages forv arious pressure ranges. (b) Internal elements of Bourdon gages. The “C-shaped” Bourdon tube is shown on the left, and the “coiled spring” Bourdon tube for high pressures of 1000 psi and above is shown on the right. (Photographs courtesy of Weiss Instruments, Inc.)

9. Pressure Transducer
Pressure is measured as an electrical output for continuous monitoring.
Figure 2.14 (p. 56)
Pressure transducer which combines a linear variable
differential transformer (LVDT) with a Bourdon gage.
(From Ref. 4, used by permission.)
Figure 2.15a (p. 57)
(a) Two different sized strain-gage pressure transducers
(Spectramed Models P10EZ and P23XL) commonly used to measure physiological pressures. Plastic domes are filled with fluid and connected to blood vessels through a needle or catheter. (Photograph courtesy of Spectramed, Inc.

10. Hydrostatic force on a Submerged Plane Surface
Figure 2.16 (p. 58)
(a) Pressure distribution and resultant hydrostatic force on the bottom of an open tank. (b) Pressure distribution on the ends of an open tank.

12. Figure 2.17 (p. 58)
Notation for hydrostatic force on an inclined plane surface of arbitrary shape.

13. Hydrostatic force on an inclined surface
First moment of the area

14. Hydrostatic force on a curved surface
Figure 2.23 (p. 67)
Hydrostatic force on a curved surface.