1. Lecture Objectives: Finish boilers and furnaces Start with thermal storage systems

2. Thermal storage for adjustment production to consumption We need a thermal storage somewhere in this system !

3. Thermal storage Store heat Many issues to consider (∆T, pressure, losses,…. ) Store cooling energy Chilled water For cooling condenser For use in AHU (cooling coils) Ice storage Compact but… Other materials (PCMs) that change phase the temperature we need in cooling coils Many advantages, but disadvantages too!

4. On-Peak and Off-Peak Periods This profile depends on the type of building(s) !

5. Chilled water tank Use of stored cooling energy StoreUse

6. Which one is better ? Depends on what you want to achieve: -Peak electric power reduction -Capacity reduction -…..

7. Downsizing the Chiller Lower utility costs Lower on-peak electrical consumption(kWh) Lower on-peak electrical demand (kW) Smaller equipment size Smaller chiller Smaller electrical service (A) Reduced installed cost May qualify for utility rebates or other incentives

8. Sizing storage system (use Annual Cooling-Load Profile) How often you need to use it? What are the cost-benefit curves ? What is the optimum size ?

9. Ice Storage Tank Many issues ! …. As freezing progresses progress the ice becomes thicker and significantly impedes heat transfer

10. Open Ice Storage Tank Also issues ! …..

11. Fluid Flow Rate and Freeze ΔT

12. Impact on Chiller Efficiency

13. PCMs A. Sharma et al. / Renewable and Sustainable Energy Reviews 13 (2009) http://www.docunator.com/bigdata/1/1367142535_c566e7d75e/reviewexample2.pdf

14. Other latent heat thermal storage systems (research is ongoing)

15. Construction and benefits Active Passive (wall)

16. Stratified chilled water tanks

17. Temperature and dynamics Temperature at outlet during the changing cycle of the tanks

18. Stratified chilled water tanks diffuser geometry Challenge: “Pull” large amount of energy without disturbing stratification

19. Modeling Write energy and mass balancer equation for each section

20. Installation of thermal storage system DownstreamUpstream Increases chiller efficiency Increases chiller capacity Overall system efficiency ??? Decreases storage capacity Simplifies system layout ….. Decreases chiller efficiency Decreases chiller capacity Overall system efficiency ??? Increases storage capacity …… Does not allow chiller shut down!

21. Mixing vs Diverting Valves

22. Plumbing arrangement in primary system Primarily-OnlyPrimarily & Secondary

23. Plumbing arrangement in buildings (secondary systems)