1. Complete the following drawing Measurements on the next two slides

2. 5-7

3. 5-8

4. Email your finished work to Mr. Scott by eplotting the file titled 5-7 & 8 your name on subject line. Your name Period Date Result of DWF6eplot Set to DWF 6eplot

5. Try this one when you are finished

6. Orthographic 5-7

7. Orthographic 5-8

8. Orthographic 5-9

9. SEND DRAWING TO TSCOTT@AUBURN.WEDNET.EDU

10. SUBMISSION OF SOLIDS, BE SURE TO LABEL

11. October 7 th We are going to begin using a Journal to save our work. All our drawings to date, with name, date, project name, and evaluation will go into the journal. They will be stored on the shelf in the back of the room by period. The goal is to collect all your work in one place. To see growth and refinement of your skills with CAD and understanding of drafting fundamentals.

12. Next drawing in the series, 5-10

13. 5-10 New drawing Create layers Begin the drawing at 4, 4 Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing. Linetype (load the Center and Hidden Lines) DDIM ( SET THE DIMENSIONS and Dimension your project.) Save-as 5-12 TSCOTT ORTHO.dwg Use your name

14. FINAL DOCUMENT: SUBMIT AS DWG TO PDF, ATTACH TO MESSAGE AND SEND TO MR. SCOTT. SAVE AS YOUR NAME, FILE NUMBER CLASS. TSCOTT 5-10 1ST

15. 5-11 New drawing Create layers Begin the drawing at 4,2 Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing. Linetype (load the Center and Hidden Lines) DDIM ( SET THE DIMENSIONS and Dimension your project.) Save-as 5-11 TSCOTT ORTHO.dwg (use your name)

16. 5-11 New drawing Create layers Begin the drawing at 4,2 Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing. Linetype (load the Center and Hidden Lines) DDIM ( SET THE DIMENSIONS and Dimension your project.) Save-as 5-11 TSCOTT ORTHO.dwg (use your name)

17. FINAL DOCUMENT: SUBMIT AS DWG TO PDF, ATTACH TO MESSAGE AND SEND TO MR. SCOTT. SAVE AS YOUR NAME, FILE NUMBER CLASS. TSCOTT 5-11 1ST

18. 5-12 New drawing Create layers Begin the drawing at 2,2 Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing. Linetype (load the Center and Hidden Lines) DDIM ( SET THE DIMENSIONS and Dimension your project.) Save-as 5-12 TSCOTT ORTHO.dwg

19. 5-13 Metric New drawing Units (mm) must change to mm. Create layers Begin the drawing at 2,2 Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing. Linetype (load the Center and Hidden Lines) DDIM ( SET THE DIMENSIONS and Dimension your project.) set the measurement scale to 25.4 (1 inch equals 25.4 mm) Save-as 5-13 TSCOTT ORTHO.dwg

20. 5-13 Metric

21. T SCOTT 10-13-2014 ENGINEERING DESIGN 5-14 ORTHOGRAPHIC

22. T SCOTT 10-13-2014 ENGINEERING DESIGN 5-15 ORTHOGRAPHIC